RC10Talk - The Net's Largest Vintage R/C Community

Hello, I just bouhgt a new build Worlds Edition with the first stealth tranny, I has the moderm rear axles to run the B4 rear wheels, can I run the B4 front rims with the original setup?

Also, the original stealth ttranny case... could I pop a current tranny into it, and run the newer slipper setup? The bearings are the same size, has anyone done this?

first off, i'm trying to figure out why you'd want to change, and run, a new built worlds car.

but anyways..........

b4 wheels will work on the front of the old rc10's. but they will narrow up the track width a bit.

you can put a complete b4 topshaft, slipper, and spur gear in the original 2.25 stealth.

Thank you

scr8p wrote:first off, i'm trying to figure out why you'd want to change, and run, a new built worlds car.

but anyways..........

b4 wheels will work on the front of the old rc10's. but they will narrow up the track width a bit.

you can put a complete b4 topshaft, slipper, and spur gear in the original 2.25 stealth.

I'm with scr8p, I don't think I would be changing anything on a new build worlds car let alone drive it!!! Thats a valuable car if it is in-fact a worlds car. Can we get some pics before you scratch it all up? I have a worlds car that was in terrable shape that I restored and I think I would cry if I ever scratched the chassis!