Page 1 of 1
Question about Hyperdrive and RC10 Trans
Posted: Sat Dec 20, 2008 8:31 am
by a01butal
Which trans can you use the Hyperdrive on? I'm looking at the spur or the bottom diff pulley as they call it and looks like the 6 gear is the only one it will work on.
Re: Question about Hyperdrive and RC10 Trans
Posted: Sat Dec 20, 2008 8:36 am
by templeofspeed
I'm pretty sure that setup predated the stealth. Pancars and sixgears.
Re: Question about Hyperdrive and RC10 Trans
Posted: Sat Dec 20, 2008 8:37 am
by scr8p
i don't have one, but i'd have to guess that at long as the holes in the spur for the diff balls line up with the screw holes on the stealths outer slipper hub, you should be able to use it on there too. or an mip trans.
Re: Question about Hyperdrive and RC10 Trans
Posted: Sat Dec 20, 2008 9:15 am
by a01butal
That's just it they don't line up with the stealth screw hole and it is a very tight fit over the outer slipper hub. I dont think it will even work with a MIP trans.
Re: Question about Hyperdrive and RC10 Trans
Posted: Sat Dec 20, 2008 9:24 am
by scr8p
i guess it's 6 gear and pancar only then.
Re: Question about Hyperdrive and RC10 Trans
Posted: Sat Dec 20, 2008 12:09 pm
by Mr. ED
Can you post a picture? If it fits over the hub maybe you could drill an extra hole in the hub and tap that (or drill an extra hole in the pulley)