RC10Talk - The Net's Largest Vintage R/C Community

And BTW Im New To The Forum. I Will Be Sharing Pictures of My Upcoming RC10 Project Soon

Welcome to Rc10talk!

the fronts are 2.1 and the rears are 2.175.

worlds car should be 2.2 rears, the rims might be 2.175 but they use 2.2 tires. Fronts are probably still 2.10 they didn't go to 2.2 fronts until the b2 or b3

the kit tires (8086 proline xtr flat stubbies) are 2.15.

Thanks im trying to get them for my gold tub project

i lost the bid

Ok, are there any variations on the World's rear wheels?
I have seen them with a "cut out" pattern? surrounding the driveshaft hole (visible from the front of the wheel) and some without. Are the one's without this special design not "real' World's wheels.
Also, the inside of the wheel has only one roll pin notch position - is this true for all "real" World's rear wheels.
Hope these questions make some sense........Thanks!

RC10resto wrote:Ok, are there any variations on the World's rear wheels?
I have seen them with a "cut out" pattern? surrounding the driveshaft hole (visible from the front of the wheel) and some without. Are the one's without this special design not "real' World's wheels.
Also, the inside of the wheel has only one roll pin notch position - is this true for all "real" World's rear wheels.
Hope these questions make some sense........Thanks!

The wheels with the "cut out" are probably Pro-Line 2577.

templeofspeed wrote:

RC10resto wrote:Ok, are there any variations on the World's rear wheels?
I have seen them with a "cut out" pattern? surrounding the driveshaft hole (visible from the front of the wheel) and some without. Are the one's without this special design not "real' World's wheels.
Also, the inside of the wheel has only one roll pin notch position - is this true for all "real" World's rear wheels.
Hope these questions make some sense........Thanks!

The wheels with the "cut out" are probably Pro-Line 2577.

^^ ditto ^^. they have the single drive pin, too.