RC10Talk - The Net's Largest Vintage R/C Community

Hi Guys I need some help I purchased a beat up RC10 that has a 1988 MIP belt drive tranny. Trouble is that I think the tranny hasn't been assembled correctly and does not run smooth at all. Does anybody have or know where I can find the original assembly sheet for this diff?

pictures would be great, but to my knowledge, only A&L and Trackmaster made belt drive AE trannies. MIP was a 3 gear - pre stealth trannie.

better guidance can be given if we know exactly which one you have.

Sorry my bad..there is a decal on the side of the box it came in that says Hyper-Drive don't know where I got the MIP from..sorry
Tizeye

do you have a belt on the spur gear or on the diff, inside the tranny? A pic would definitely help tohether with more details about your problem...

It's on the spur gear..to the pinion(of course) on the outside..came with several different sized spur pulleys? and different sized belts and it still fits inside the original RC10 gear cover..yep I'll get some pic's taken..
Cheers
Tizeye

There's a thread in here somewhere on how to build a 6 gear the right way, the hyperdrive just goes where the spur and pinion are correct?

Yep exactly the same..cheers I'll see if I can find that darn thread..

have a look here for the Hyper-Drive belt: http://www.rc10talk.com/viewtopic.php?f=35&t=6854 (last pictures of the thread) and here for rebuilding your 6-gear tranny with Jim Halsey: http://www.rc10talk.com/viewtopic.php?f=7&t=3748

Note that if you plan to actually run your car with the Hyper-Drive set-up, you'll either need a reverse motor or swapping the motor plate to the left...

hope this helps!

Cheers for all of the help guys..I'm going to put it in a Big Boys Toys sprintcar when it arrives..will keep you guys updated

Tizeye