Page 1 of 1

Pin the diff rings on a Stealth Trans?

Posted: Mon Jan 05, 2009 9:27 am
by Group B
Since I'm not having much luck finding d-ring outdrives and d-rings for a Stealth Transmission, does anyone have any recommendations on how to pin the diff rings on the Stealth Trans in my 10T?

Re: Pin the diff rings on a Stealth Trans?

Posted: Mon Jan 05, 2009 9:28 am
by scr8p
ca glue. :wink:

Re: Pin the diff rings on a Stealth Trans?

Posted: Mon Jan 05, 2009 9:46 am
by Asso_man!
I must have built almost every possible RC10, but I've personnally never seen D-ring outdrives nor D-rings for a Stealth tranny! I don't see why you would like to "pin" your diff rings either... The Stealth trans is/was one of the best out of the box, just carefully follow the mounting instructions...

More tips here: http://www.rc10talk.com/viewtopic.php?f=7&t=3721

and here: http://www.rc10talk.com/viewtopic.php?f=7&t=1292

Re: Pin the diff rings on a Stealth Trans?

Posted: Mon Jan 05, 2009 9:35 pm
by Bugle
TC3 rings could be considered to be for a stealth tranny since they're the same ID, OD but with the D flat bit, haven't seen any outdrives though.

I dont think i've had normal diff rings slip anyway.

Re: Pin the diff rings on a Stealth Trans?

Posted: Tue Jan 06, 2009 12:20 am
by wyldbill
nobody ever made d-ring outdrives. the only way they can be made is to take existing stock outdrives and machine the inner lip flat on one side in a milling machine. i have made all of my racing ones d-ring outdrives but i only did it to my aluminum outdrives never on stock steel ones. then i use tc3 or losi d-rings, i can even go back to using stock rings if i run out of d-rings.