Page 1 of 1
Need help identifying these parts, tub chassis....
Posted: Sun Jan 18, 2009 5:33 pm
by Jay Dub
Just picked up this car the other day. I know it is a YZ-10, and that it has the fybre-lyte tub chassis, shock towers, and upper plate. But I am looking for specifics, such as model, type year maybe-anything to get a better idea of what it is. Thanks in advance for your help. -Jeff
Re: Need help identifying these parts, tub chassis....
Posted: Sun Jan 18, 2009 5:41 pm
by GJW
looks like a pavidas
nice find mate..very very lucky
Re: Need help identifying these parts, tub chassis....
Posted: Sun Jan 18, 2009 6:37 pm
by bscotti
I have the exact same one. It's a conversion for the '95 model YZ10. It's awesome for sure!
Re: Need help identifying these parts, tub chassis....
Posted: Tue May 12, 2009 1:58 pm
by Jay Dub
Forced to sell
, check e-bay section. Thanks-Jeff
Re: Need help identifying these parts, tub chassis....
Posted: Wed May 13, 2009 5:59 pm
by Mr. ED
actually the guy's name is Pavidis , not Pavidas I think?
Re: Need help identifying these parts, tub chassis....
Posted: Thu May 14, 2009 4:25 am
by Asso_man!
Mr. ED wrote:actually the guy's name is Pavidis , not Pavidas I think?
exactly, Mark Pavidis
Re: Need help identifying these parts, tub chassis....
Posted: Fri Oct 22, 2010 3:54 pm
by Timanidzer
dude.how are you fixed the servo
i'm don't understand that it %)
Re: Need help identifying these parts, tub chassis....
Posted: Fri Oct 22, 2010 7:45 pm
by Jay Dub
I don't know. I received the car as is, and never ran it. It was propably servo taped, or shoe gooed. If I remember, the servo arms had been removed?. -Jeff
Re: Need help identifying these parts, tub chassis....
Posted: Mon Oct 25, 2010 12:55 am
by Bormac
Jeff that would have made for a seriously awesome vintage racer. I hate that this hobby is worth and can generate money at times. Well not hate but it makes it tough to hold on to nice cars when you have extra and unaccounted for bills at times.
Where did the car go to if i may ask?
Re: Need help identifying these parts, tub chassis....
Posted: Mon Oct 25, 2010 2:29 pm
by Timanidzer
show yor servo little closer
how servo installed
Re: Need help identifying these parts, tub chassis....
Posted: Mon Oct 25, 2010 4:44 pm
by Coelacanth
Timanidzer wrote:show yor servo little closer
how servo installed
It's probably just stuck on the bottom of the pan with double-sided tape. That's how most servos are "installed".
Re: Need help identifying these parts, tub chassis....
Posted: Tue Oct 26, 2010 7:48 pm
by Jay Dub
It went overseas, Japan maybe (?). I raced a yok from that era for a while (bitd), and hated it. I didn't understand chassis dynamics as much as I do now, and with out the benefit of the R&D parts and setup knowedge from the factory drivers it was a year long nightmare. I guess you could say it was "educational". -Jeff