RC10Talk - The Net's Largest Vintage R/C Community

anybody have a pic and measurements for the spacer between the rear hub bearing and the drive pin? mine are missing and i might make a few on my lathe, thanks.

never mind, i found them online, you can still get them. I thought they might be hard to get.

There are 2 versions depending on the type of rear hub you're using. If you're using the the hub for the 5 link, then you need the thick single spacer (1 on each axle). If you're using the smaller hub, then you need the 2 thin spacers (2 on each axle).

Regards,
highwayracer

Are there 2 versions of A-3016?

I've always used the same spacer on all rear hub types, did not know there was any other.

I need some of these too....Zip tie will not last long....

http://www.horizonhobby.com/Products/Default.aspx?ProdID=LOSA3016

$2 for 2
I made some out of aluminum tubing from the lhs. Not as pretty as the factory ones, but for the same $2 I got enough tubing to make a ton of these

aconsola wrote:http://www.horizonhobby.com/Products/Default.aspx?ProdID=LOSA3016

$2 for 2
I made some out of aluminum tubing from the lhs. Not as pretty as the factory ones, but for the same $2 I got enough tubing to make a ton of these

I think I will find some tubing as well...