RC10Talk - The Net's Largest Vintage R/C Community

Well My 10T was looking pretty bad after 12 years. The pan was bent it was really dirty and needed bearings. And the tub has a lot of nicks in it. So I took it all the way apart and cleaned everything. but I tried something a little different to make the pan look good. I took a sharpie and colored it in and then I took all the sticker i had and put them on neatly and put the 3M film that AE sell over them.

It's probably obvious to everyone but me, but do you know exactly who makes that body and if it's still available? I'd like to find something that mounts cleanly that isn't stadium truck style.

The body is a 70 ford made by proline.

Truck looks good I have never seen a 10t with a rear sway setup. Nice old vintage look with that body.