RC10Talk - The Net's Largest Vintage R/C Community

Orange construction barrels.

Why is there a Hex Hole in the caster blocks.

Drivers who stop at the Red Light look both ways and drive right threw it. Very common in the Detroit area the total disregard for traffic laws and signage.

Hello and hope everyone is doing good. I wanted a car stand that didn't have a large foot print and had to be easy to move. Bottom is a Bar Stool seat and the rest is 1x3's. I am not a carpenter or wood worker by any means and to be honest I am terrible at both so it amazes me that these came out fa...

Monark192 wrote: ↑Tue Jan 17, 2023 10:47 am How was the event? Any pictures??

https://www.youtube.com/watch?v=smBF4CLTVD8

Monark192 wrote: ↑Tue Jan 17, 2023 10:47 am How was the event? Any pictures??

https://www.youtube.com/watch?v=smBF4CLTVD8

Losi XXXT CR

When calling a company the never ending phone prompt's, press one and say this, press two and say that, etc. then you get someone with a strong foreign accent that you can't understand is currently the top irritating thing on my list.

Both plates will work with brushless. The V2 works with both brushed and brushless motors.

Dynotech has two conversion motor plates. Get the VER.2 If you plan on running brushless.

I haven't measured a roll pin but here a few at 1/6" x 3/8"
https://www.mcmaster.com/roll-pins/slotted-spring-pins-6/diameter~1-16/length~3-8-2/

This is my RC10 cadillac built about 20 yrs ago and never ran. Body and wing are not the kit body as I messed up the original body cutting it out.

Nice work. I have never seen a diff. shaft with a screw retaining the bearing. I always hated that E clip.

This is my XXXT CR. Has a Boki Racing XXXT CR body.