RC10Talk - The Net's Largest Vintage R/C Community

Yep windshield wipers, I had them flipped up while I was washing the car

I took this several years ago. Any guesses where he's at?

Finally resolved my "pre-order" after a little over a year. Originally supposed to be one Renegade and one B2. Don't know whatever happened to the B2 re-launch.

Ed nailed the issue with the bulkhead. It is quite complex to machine since the bulkhead has to be setup 4 to 5 times to fully machine. Rught now the best bet is to cut your bulkhead using a variety of dremel and sharp xacto. if you take your time, you can end up with a really nice part that will l...

You can get the rpm motor guards direct from them , they are the standard associated part just black... In case anyone wants an aluminum one... whats the link ? I couldn't find them Edwin This is the reply I received when I sent RPM a message on FB asking them if they had any left: we have a lot of...

No body yet. Still looking into that and an HPI wheel conversion.

I was putting the parts bags away after I completed each section and these spacers and nut were leftover from the bags involved with building the tranny. I had all the shock spacers needed when I got to those bags. Plus they are 1/32" thick in this kit. I went back and checked the manual and it...

OK thanks. Just wanted to make sure I didn't miss something.

I have a DS Racer's kit I'm building from NIB. After building the tranny I have these 2 plastic washers left but I don't know where they're used and can't find them in the manual. I also ended up with an extra locknut. The washers measure 1/8" ID x 1/4" OD x 1/16" thick. Any help? htt...

Thanks! Paint was by Larry at Kustom R/C graphics. I was going for a boxart-inspired scheme but not a copy. The final product wasn't exactly what I asked for but I still like it. It's hard to explain in an email every detail so until I make attempts to paint on my own I'm okay with close.

Only have one re-re completed so far and with the little bit of a run going on here with worlds car posts I thought I'd add mine to the mix. Kept it stock except for white wheels, RPM gear cover and Steve's front bumper. My kit also had the bad topshaft and gear mesh issues in case anyone is countin...

Yes. Two 1/2" long SHCS are included.

Jconcepts Body for worlds

Or drill for the correct worlds lengths :mrgreen: i want them for use on pre-worlds cars (replicas and such). i can't be drilling holes if the car i'm copying didn't have them. :wink: even the rere worlds kit comes with the shorter rods for the rear. :? so no wonder lunsford made them like that. Th...

Proline Blades, p/n 8179M3. My set has the knobs closer to the sidewall w/lettering.