RC10Talk - The Net's Largest Vintage R/C Community

This is our new chassis set for the Fox and Nova Fox. It took us a while to come up with this design. We use a similar interlocking setup as our Hotshot. We have two sets of servo mount holes, you can leave it offset or center it up. We designed it to reuse the driver figure because, well, its kind ...

Can't help the addiction Alex

My mailbox still says hello

I've just made the 400,000th post!

Thanks for making this place what it is today. I value everyone here more than you know.

For all of you who can live with hex wheel adapters here's what I use for modern 2.2" rims: THESE HPI Adapters The "red" ones are a direct fit to the 1/4" axles, BUT you have to sand down or cut off the part circled yellow (for buggy rims and non HPI truck rims) If you combine t...

Tamiyadan gone ! That's a real loss , he was helpful and insightful ,its a shame . I agree, it is a shame. I really hope it wasn't due to anything that I said. Dan had made 2532 posts so it must have taken him a lot of time to edit and replace them with a dot. He will be missed. If this is what hap...

Damn.... slow month.

Modifications are back to functioning properly besides the lightbox images mod. I have to reinstall that, and still make a bunch of little changes. That won't be until later today though as it's past 5:00am here and I'm going to sleep.

Printing the other three gears together was a mistake , nothing too bad but there was a bit of stringing that needed cleaning up , no pictures I'm afraid but they are fitted and I've test run the gearbox out of the car , now its installed I'm going to test drive it tomorrow , see if it lasts 5 minut...

Has some time and got it done. See if you can figure out which one is original Shoot me a pm back with your email address whenever you are ready for it

6565 is the original style case which actually fits and works well lol. It is identified by the 4 individual spacers that go between the trans and the motor plate. Use a 6570 idler. 6564 is a pos that was developed for the rere Worlds car. It has the spacers built in and features a tight gear mesh o...

Incredible_Serious is the Schumacher Nitro 10 master and I'm sure he will chime in at some point. One of the most common problems I've seen with nitro cars that have been sitting for a while is the fuel coagulating in the carb. Pull the line off the exhaust, manually open the carb to full throttle a...

Interesting, it's exactly the same..... who knew.... Thanks for sharing

I've just whipped the Leo 12 engine out of mine. From the look of the instructions [thanks to Incredible_Serious], the whole engine plate needed to be removed. This was ok - I removed the tank, and the plate fixings, and removed the four screws which hold the plate and the transmission. What I found...

I think its finished , now I just need to print another complete set of parts to make sure all my alterations work together ... Not sure I can face it right now :roll: . I guess before that I should fully stress test the prototype , I had what I'm hoping will be the last part failure today , the las...