my worlds composite craft rc10 on a budget

[hugger19]

since i have so many used parts iam going to use em on this build PLUS been spending a lot of money lately so i know it wont be 100% correct build so no stupid comments please only new parts will be the rear hub carriers by shapeways, frt/rear shock towers & battery strap by gomachv and the stealth outdrives x2 since i didnt have any extras.

[jwscab]

there is no such thing as an 'incorrect' build. build it how you want.

looks like a great start.

[hugger19]

well almost everyone i have seen uses all rpm arms and parts. iam using a rc10t nose with rc10 arms and andys rear arms. had to trim down the bulkhead to make those rc10 arms fit.

[klavy69]

there is no such thing as an 'incorrect' build. build it how you want.

looks like a great start.

X2...on both parts

[jwscab]

Well yeah guys build them with RPM parts because the width changes. What you have will be pretty narrow.

[hugger19]

ya thats what i was told. no biggie

[klavy69]

I think it will be pretty steady on the shelf

[mikea96]

You can use Niki's printed arm mounts and dynotech front and rear arms.

[hugger19]

I think it will be pretty steady on the shelf

u r correct

[hugger19]

just a small update. the rear motor guard i made from a old chassis just cut the back off.

[hugger19]

well its done. the back of the car came out a bit narrow, well at least i think, i could be wrong.

[jwscab]

no, she will be narrow, without the 'correct' rear arms.

[hugger19]

u have any pics (or anyone) of the correct rear rpm arms in white?/or part numbers?

[transamman908]

Rpm Rear narrow arms are #8017. Correct rear suspension mounts is #8021.

[RC10resto]

Eddie should have just showed you this

http://www.rc10talk.com/viewtopic.php?f=35&t=15031&hilit=Composite+Craft+Worlds