Hello everyone. I recently have gone back to indoor off-road racing this winter after a 7-8 year absence. I'm currently running a 4 wheel drive buggy but I took my old trusty T4 off the shelf and want to put it back in action. My questions are :
Last time a raced this truck we ran nickel metal cells, now it's going to be a lipo. Should I add the weight under the lipo? How much more weight should I add and where?
Does anyone have a setup I could start with. I am racing at Leisure Hours raceway in Joliet IL.
Thank you
HOWEVER, I added a bunch of weight to my T5M, and it handled better. I tend to drive heavy vehicles better than light ones. They're too twitchy for me. Sooo, if your RC10T is being twitchy, then it may be a good idea.
Anyone have a good racing setup for a gold pan?
My car will have the a&l trans,wide front end with Andys front arm holder,rear b2 cvds (2.2 wheels) and stock everything else. The rear upper link has been re-drilled already to make it longer.The pack...
Last post
that' s the setup I always ran, If you run a lipo probably put 1 oz of weight somewhere under the battery.
Hello.
I have been running my gold pan in our 2wd buggy class this year. I have been doing pretty good with it (usually top 5) believe it or not. I am using a full gold chassis ,stealth trans, b2 cvds modern tires
with Mark W setup from here-
I...
Last post
HELLO aLL THIS IS YOUR OLD PORTLAND RUSTBUCKET . It has been a wile since I have been on the board. I see there is a set up post. OK maybe some of you can help me again like you have allways done.
Can some one tell me how to set up a stock gold...
I have a TRX 1 that I intend to run through the winter here in the UK.
What I would like is a good base starting point : ie
Shocks, what pistons front and rear
what wt oils and springs, although the spings I have are not coloured
what length shock...
Last post
I was in the lead for an auction on a descent TRX1 this week, but 1 day before it ended the auction got pulled by ebay :| Don't know the reason it as pulled, so better look at it positively; maybe they saved me from a scammer :P
I built a mutt truck out of parts I had got in a parts lot I bought. Here are the parts I am using.
Rc10 gold pan b chassis and rear bulkhead with rear a-arm mounts
Rc10 gt plack pan rear a arms castor blocks driveshafts
Mystery black transmission...
Last post
Sorry I havent been able to update I had to leave town for work, but before i did I found an original rc10t truck on graigslist, I will use this guy for parts on that and a buggy I am working on. I will start a new thread on the c/l truck.
Been on a mission to resurrect the old JRX2 and here's what I'm going to run...not ready to go brushless yet because I'm not ready to spend the money...already sunk way more into this project than I planned!
18x5 brushed motor
Losi LRM tranny...
Last post
lipo with 27t stock will be enough, even with 18x5 your still fine with your set up