As with everything, it's all in the prep and products used. Every graphite chassis I have restored I use a DuPont 2322s adhesion promoter for plastic as my "clear coat". It's super thin, goes on super flat and dries to a nice satin sheen. Now granted, most of the ones I've done have not seen use. But I have installed and removed electronics in them and the servo tape does not pull it off.
The one chassis I did was used at the '08 Vonats and it doesn't really look any worse than an untouched used graphite chassis I have.
Now if I was going to try filling in scratches I would first use the adhesion promoter. Then build the clear up on that. Much better chance of it sticking.
Carbon Graphite Chassis Refurb
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 5 Replies
- 192 Views
-
Last post by GoMachV
-
- 12 Replies
- 772 Views
-
Last post by PBR Allstar
-
- 4 Replies
- 885 Views
-
Last post by Millsie23
-
- 3 Replies
- 857 Views
-
Last post by Kayne
-
- 5 Replies
- 3104 Views
-
Last post by fordtransman
-
- 3 Replies
- 857 Views
-
Last post by glastornjet73
-
- 7 Replies
- 943 Views
-
Last post by slvrback
-
- 6 Replies
- 947 Views
-
Last post by slim_chance
Who is online
Users browsing this forum: 
Facebook [Bot], 
radioactivity and 2 guests