Pionion question

[Jschoenb]

I'm relatively new to rc cars/trucks and I finally got my two RC10t bashers running after about a year. I was wondering if I need special pinions specific to the for the RC10t (stealth tranny) or will any do?
Thanks

[scr8p]

any company's pinion will work, as long as it's the same pitch as the spur gear on the trans.

[Jschoenb]

Thanks for getting back to me. Might sound like a dumb question but how do I know what the pitch is on my spur gear?

[scr8p]

Thanks for getting back to me. Might sound like a dumb question but how do I know what the pitch is on my spur gear?

it'll tell ya on the pack when you buy them.

honestly, i don't know if there's a method to check the pitch. i just know by looking at them. if your not sure, i'd just buy a new spur and pinion in the same pitch. 48 pitch would work just fine.

[Jschoenb]

Ok thanks for the help I think I'll do that.

[badhoopty]

they should have 48p spurs on them unless somebody swapped ia different one.

you can also buy a pinion set off tower that has like 5 different pinions in it so you can play around with gearing.

i feel like i should have a sig that's a disclaimer saying i could be wrong on any advice i give...

[scr8p]

ya, definately get more than one size pinion. the rc10t came stock with an 87 spur.