That headline had to get some attention! I think I have it figured out though, I did a quick and dirty fitment and it looks like the parts I have pieced together are going to work! I'll post some details and pics when I get it finalized and some parts made that look like I spent more than two minutes at the lathe.
My main question though is do you think it would be okay to have .200" more track width to the car front and rear (.100" per side)? I know it will put just a bit more load on the hub bearings front and rear, and add a bit to the scrub radius in the front but other than that does it seem okay?
ford
thanks again tulsa and shodog!
2.2 CVD equiped yokomo 870c
- PBR Allstar
- Approved Member
- Posts: 805
- Joined: Mon Apr 30, 2007 10:30 pm
- Location: Sonoma, Ca
- Has thanked: 1 time
- Been thanked: 3 times
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 7 Replies
- 1432 Views
-
Last post by flustorm99
-
- 26 Replies
- 3810 Views
-
Last post by DerbyDan
-
- 14 Replies
- 2065 Views
-
Last post by Alex B
-
- 16 Replies
- 1900 Views
-
Last post by Synergy
-
- 2 Replies
- 932 Views
-
Last post by kenooze
-
- 17 Replies
- 2667 Views
-
Last post by caesar
-
- 10 Replies
- 1780 Views
-
Last post by mrlexan
-
- 12 Replies
- 3011 Views
-
Last post by _timmy_
Who is online
Users browsing this forum: No registered users and 0 guests