i wanted to see if it was at all possible to use the gt2 slipper assembly and brake rotor on my gt with a b4 topshaft, and low n behold it all works.. the gear lines up as well as the brake rotor with the shoes
the only mod that had to be made was to ream out the output hole on the trans so the slipper/brake hub could meet up to the bearing inside the trans with the help of an additional top shaft spacer "same spacer used on the inside of the gt on the top shaft"
now i can use the gt2 spur gears and the losi Kevlar gears
this was all done so i could use the 54-56 gears on my gt that i use in the sand dunes, i will be posting some pics of the build soon.
rc10gt slipper upgrade
- lowrydesign
- Approved Member
- Posts: 574
- Joined: Thu Jan 01, 2009 6:40 pm
- Location: Arizona
- Has thanked: 11 times
- Been thanked: 17 times
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 5 Replies
- 822 Views
-
Last post by SnoopMaxx
-
- 10 Replies
- 714 Views
-
Last post by KidAgain
-
- 36 Replies
- 9421 Views
-
Last post by NomadRacer
-
- 2 Replies
- 137 Views
-
Last post by JRxJoe
-
- 4 Replies
- 866 Views
-
Last post by JosephS
-
- 9 Replies
- 1831 Views
-
Last post by Sixtysixdeuce
-
- 2 Replies
- 927 Views
-
Last post by Joe6Pack74
-
- 4 Replies
- 1346 Views
-
Last post by GoMachV
Who is online
Users browsing this forum: No registered users and 5 guests