rc10t 3 piece wheels

[Norman]

I just had a quick question about the 3 piece wheels that came on the rc10t. Are they 2.2 and are you able to put newer type of tires on those rims.

I want to keep the vintage look to my rc10t but dont want to use old tires. i would rather use newer proline rubber.

Thanks.

[adam lancia]

Yes and yes. You just need to be cautious about how much power you put through the wheels. I'm not sure how well the 3 piece wheels will hold up if you're planning on going LiPo/brushless. Maybe someone else here has tried and could give some input...?

[Lonestar]

Yes and yes. You just need to be cautious about how much power you put through the wheels. I'm not sure how well the 3 piece wheels will hold up if you're planning on going LiPo/brushless. Maybe someone else here has tried and could give some input...?

I haven't tried but I don't think they'll suffer that much from power, not any more than the 1/16th roll pin or so that's driving them . However, tires aren't glued in there, so this could be an issue at some point.

Best,
Paul

[Norman]

alright thanks. i might just go for the one piece wheels then. i was thinking about put a lot of power in the truck. It was going to be built as a everything car.

[Lonestar]

i might just go for the one piece wheels then.

I must be missing sthing

[Charlie don't surf]

I had trouble with the current tires on the 3 piece rims because of the foams getting in the way of the seating of the bead no matter what I did, so they really likes spitting tbd tires off!