Another Sand Scorcher Shell

Post by **soniccj5** » Sun Sep 04, 2011 6:59 pm

I have been getting my body ready for the VONATS concours.

Today I put down my second color and I think it came out ok. I did learn that if you pay for good masking tape it makes a huge difference. I used a mixture of Fastkolor and 3m masking tape. I found that the Fastkolor did not bleed and made for much sharper lines.

Next comes the clear coat and some more wet sanding.

: sandscorcher-01.jpg (73.07 KiB) Viewed 852 times

: sandscorcher-01.jpg (73.07 KiB) Viewed 852 times

Post by **shodog** » Sun Sep 04, 2011 9:42 pm

A tip for clean cuts is to spray clear over your tape to seal it before spraying your next color

Post by **mrhemi1971** » Sun Sep 04, 2011 9:53 pm

Looking good! Keep posting pics! I hope to pick one of these up someday.

Post by **soniccj5** » Mon Sep 05, 2011 9:31 am

shodog wrote:A tip for clean cuts is to spray clear over your tape to seal it before spraying your next color

Thanks for the tip I will try this on my other body.

RC10Talk - The Net's Largest Vintage R/C Community