The diff out drives on my Stealth trans are a little oxidized. Can you all share some of the best ways to clean and restore them. I was considering using metal polish but I am a little hesitant.
I think I remember seeing a few post on how these are hard to find. Which ones are the ones everyone is looking for. I found a bunch but before I purchase them I want to know which ones people need.
Anyone know what application the MIP Lite Drives, PN: 1190 are for? I have a header card that is missing a sticker. Help would be appreciated. Thanks!
Jay
Last post
ok, jay. i'm 99.9% sure they're for the b2/b3. here's why. i was googling around and found one page. they had a list with the numbers, but vague on the description. the ones i have for the 2.25 stealth are 1188. i figured that the t2 and gt would be...
I have always run o rings but in my high speed GT2 I installed springs to remove any slop in the bones back in 2017. CVD pins will not hold over 80mph even with super glue red loctite, and a heat shrink boot. The pins leave the bone and cut the rear...
Last post
The SG or Tag Coyote had little springs in the diff out drives , possibly others , only disadvantage I can think of is they drop out during servicing and O rings tend to stay in .
The springs I seem to find fit in the RC10 3/16 Outdrives only...
Im pickn up a rc10 lot sunday evening and he says comes with a chain drive tranny but not seen any to kinda get an idea for which one it might be so i know what it is before i purchase this stuff.Apparently theyve been only oval raced one is the...
Last post
Well i just picked up a big time capsule.1990 TO1995 two caddilac rc10s with MIP sp-1 tranny and the team pit stop chain drive tranny,both cars have titanium dogbones and theres one dogbone with white balls on ends that titanium.Think someone here...
Does anyone know if the custom works 4475 out drives fit the rc10t2 diff/trans case?
Last post
Looking at photos of them, they look to have a flange on them that is wider than what is needed for a t2 transmission where the outdrive bearings sit. So they look like they won't fit.