Hello i have a bit of a problem a screw has snapped off on my T2 one of the screws that fixes the transmission case to the chassis its snapped off about 3mm in im bit worried to drill it out, is it possible to get a new transmission case and has anyone got a part number or if it is used on a b4 or any other associated buggy/truck
Associated 7375, I see a couple for $10 on the US Ebay site
It's time to stand up to the bully. Support the companies that support the industry, not the ones that tear it down. Say no to Traxxas Factory Works website
I got a kit off of ebay with a bunch of spare white parts, and there was a transmission case with it that I have not seen before. It is a 6 gear case but appears to be machined, not moulded. The nylon also appears to be denser and it is a lot...
Does the RPM transmission case need to be modified when using a worlds chassis and world rear arm kit? Can I use a stealth transmission case without modification?
Last post
stock stealth case fits fine with the narrow rpm rear end.
you will have to mod the rpm case for clearance when using it with the rpm narrowed rear and/or rpm rear bulkhead. its not hard at all if you are familiar with a dremel.
It looks like there was a broken aluminum screw that broke and someone tried to remove. Unfortunately it looks like someone tried to drill it out but the screw is partially there. For the hole i was thinking a out trying a 4-40 heat insert but...
Last post
z4TVnbuy4Lw
Wow! I wonder if it would cause any issues with residue if I put a steel screw back into the hole after? There must be some sort of neutralizer that can be put on it after.
Far as I know it's only ally that gets eaten, it's on the...
I'm building a Bullet from the ground up and was lucky enough to source almost everything minus the transmission cases. I bought perhaps the roughest Bullet ever from eBay as a guide(im still itchy from cleaning it) for this and the cases are just...
Last post
I definitely plan to keep this one going klavy69, at least for a few runs before the eventual shelf.
I have a few other projects going at the same time as well. My thinking is while restoring one and I come to a parts snag, I move it aside and and...
i installed the rpm trans case in my graphite rc10 project and i know the ratio is different but forgot the ratio was. im currently running a 17.5 in it and its dog slow with an 81 spur and a 26 pinion. just wanted to know a good baseline so i dont...
Last post
Raced 36/75 tonight with the ballistic timing at 40 degrees. About 100f after an 8 minute main. Going to change the spur to a 69 tooth next.
