Losi Pro SE Arm Question

[oldskool]

I have a Pro SE with mismatched front arms. Looks like it has one JRx2 Arm and one Pro SE arm (broken). Since Pro SE arms seem hard to find, can I use a modern arm (like a XX or XXX) instead?

[highwayracer]

Unfortunately, the arms from the newer cars are too wide. Let me check to see what arms I have...I thought I had some for the pro se.

regards,
highwayracer

[mrlexan]

I think I have one extra.... I want to say last time I looked at it, it was a bit different than the ones installed on my car. By that I assume there were two versions. You can have it if you like.

[bearrickster]

Yes the Jrx 2 arms will work I have 1 single arm also let me know if you need it. I just bought a Se on E-bay it had XXX arms on the front he had to cut down the front bulkhead it worked but I would have cut it in the back he removed the mat. from the front so the arms are a little far back for the shocks.

[Chewbacca]

Just by looking at that pic above I am pretty sure, that those xxx arm are way too long. Ithink I have a pair of swept arm I don't really need. But I've seen front JRX-2 arms around evilbay often enough. The cool thing about the original front arms is that there ain't no left or right.

[Chewbacca]

I know not cheap, but you might want to give THESE
a try. Indestructable rpm arms, those are also on my bro's Jrx ProSE.

[bearrickster]

Yes they were quite wide the whole set up was scraped and replaced with new stock swept arms and new bulkhead I was just showing how the XXX arms fit on this car, or dont fit is more to the point they arent a very good idea on the Jrx cars. thats all.

[Brandon G]

Merry X-mas:

http://www.ultimatehobbies.com/istar.asp?a=6&id=LOSA1013!1002

Maybe they actually have it?

[JK Racing]

Merry X-mas:

http://www.ultimatehobbies.com/istar.asp?a=6&id=LOSA1013!1002

Maybe they actually have it?

I may have to drive over there and see....