I saw some discussions on this topic but not sure if there is an answer out there. I’m wondering if anyone has lengths for the bones for part ASC 9756 rear B44 CVA . I just need the bone length. End to end or center to center. Trying to piece together some parts as I cannot seem to find a ASC 9756 rear B44 CVA anywhere. In case I am using the wrong terminology I have attached a photo of what I am referring to as a CVA bone which I’d like to know the length of for the 9756 part.
I May have just had a premonition here.
The whole cva assembly for the b44 is part ASC 9756 but the individual dog bone for rear of b44 is 9754 can someone confirm if I am correct? Thx!!
I have a CVA but not sure which ASC number it is. I believe it might be a ASC 9754. Tried finding the length end to end online but no luck. Can anyone help with this?
Thx!
Last post
Yes the pic is great thank you. With my less sophisticated measurement device I’m about 63-64 mm. So it’s likely the 9754.
Thanks guys!
anyone have the length of the front cva bones? end to end would be awesome, also... if theres a difference in length of the center bones, i could use those two numbers too... and finally, do they differ between the .1 .2 and .3?
Last post
I have some lengths listed in my RC10.44 build thread.
Hi all, the intention of this post is to serve as a reference point detailing how to duplicate some of the rear end setups I've used and get a lot of questions on.
I'll preface this by stating that there are a lot of different CVA/CVD and...
Last post
Very good 8) Thanks for taking the time to explain in great detail all the items necessary for this conversion.
In switching to 3/16 Axles on my Runner, I started looking for some Bones. I grabbed a Pair that looked the closest to fitting. They did, but on closer inspection, I noticed the Pins through the Ends were 90* of each other. Ive now looked at most of...
This is the RC10T I picked up and I'm just running it as a runner for some play time for now, but for some reason the Dog Bone popped out on one side and now it seems like it's to short and it doesn't fit. I've taken both sides apart to compare them...
I would really like to run my Bulldog this weekend at our vintage get together but I am missing a front drive shaft,does anyone know of one that would fit from a different car.I tried Ultima but it was too short.If worst comes to worst Ill lengthen...
Last post
Thanks guys,I eventually found one that fits in a ebay junk gas car that blew both diffs the first time it was run.I think it was smartech brand.Atleast I finally got to use something from it.Please bring your stash still Gary as this one is a bit...
I ran across something weird. I was working on my A&L trailing arm car and started cleaning the dog bones and noticed the ends were plastic. And glued on! What's up with that? Is this part of the original A&L kit or some weird hop up / option part....
Last post
I remember reading a tech article about the 90 degree offset on the bones, it was to reduce scrub during suspension compression. Dont ask me to explain it, I just remember that odd fact from the article. I want to say I read it on here from a race...
Bing [Bot], 
radioactivity and 5 guests