mamba misery

Moderators: scr8p, klavy69

2 posts • Page 1 of 1

tulsa: Approved Member; Posts: 615; Joined: Mon Jan 22, 2007 10:18 am; Location: pa. usa

mamba misery

Quote

Post by tulsa » Sat Jan 31, 2009 1:52 pm

ok you mamba max guys i got a used system. when everything is hooked up and i go to calibrate it to the radio all i get is the tones and a flashing red light

and no steering. anybody got any ideas

http://www.sportsonlyauction.com

tulsa: Approved Member; Posts: 615; Joined: Mon Jan 22, 2007 10:18 am; Location: pa. usa

Re: mamba misery

Quote

Post by tulsa » Sat Jan 31, 2009 4:07 pm

got it fixed up and runnin. tore it apart and found 2 reciever wires departed from the board.

http://www.sportsonlyauction.com

Post Reply

2 posts • Page 1 of 1

Create an account or sign in to join the discussion

You need to be a member in order to post a reply

Create an account

Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute

Sign in

Similar Topics

Replies

Views

Last post

Well it happened again BADLUCK MISERY

Last post by THUNDERSTRIKE1 « Tue May 08, 2012 9:56 pm
Posted in Off-Topic / Chit-Chat
Replies: 10
by THUNDERSTRIKE1 » Sun May 06, 2012 2:12 pm » in Off-Topic / Chit-Chat

First post

Down at Atlantic beach seeing my kids.Got up saturday morning went to store across 5 lane highway 24,was trying to leave the parking lot but traffic terrible sat for 15 minutes tryn pull out.
Finally get a clear spot to pull out and i make to the...

Last post

So far with my adjuSter at PROGRESSIVE WHOOM SEEM TO BE A COMPLETE IDIOT that couldnt understand how to pour piss out a shoe with instructions on the bottom.I had to tell her umpteen dozen times and she still couldnt figure it out by phone.But...

10 Replies

1251 Views

Last post by THUNDERSTRIKE1
Tue May 08, 2012 9:56 pm
The end of my Mamba

Last post by treehugger « Tue Jun 21, 2011 5:59 am
Posted in Modern Electronics
Replies: 4
by treehugger » Fri Jun 17, 2011 8:40 pm » in Modern Electronics

First post

So after trading a flurry yellow DS with no thumbs, and having allot of bashing fun with it .
I decided to go to the castle site and download the updated soft ware MMM , my first mistake LOL i must have pushed the wrong button ,as now all i have is...

Last post

I did that once to my mamba max (before going to the pro), i updated the firmware on the PC, but not the speedo, changed some settings and it stopped working.

Trying hooking it back up to the pc and pushing a firmware update to the speedo, then...

4 Replies

754 Views

Last post by treehugger
Tue Jun 21, 2011 5:59 am
Broken Mamba switch

Last post by treehugger « Wed Apr 20, 2011 2:26 am
Posted in Modern Electronics
Replies: 5
by treehugger » Mon Apr 18, 2011 5:33 pm » in Modern Electronics

First post

So the switch Wire from the pc board on my mamba just parted off , :roll: so my Q is can i bridge the two pins coming of the pc board . and switch it just after the battery s ? this would isolate the whole system !

Paul

Last post

Put your Mamba into Smartsense mode, it will work without a sensor. Novak has a pretty nice trade-in program though, You can trade in that old motor for a new Ballistic. The good thing about a ballistic is the sensor wire is not permanently attached...

5 Replies

660 Views

Last post by treehugger
Wed Apr 20, 2011 2:26 am
LIPO Recommendations For The Mamba Max

Last post by Bongo Fury « Thu Nov 20, 2008 9:43 pm
Posted in Modern Electronics
Replies: 3
by FasterLouder » Thu Nov 20, 2008 11:22 am » in Modern Electronics

First post

I have a Castle Mamba Max with a 5700kv motor.I love it,it is everything I could ever ask for in a brushless setup. :mrgreen: :twisted:
I've been running NI-MH batteries and lately,a few of them died on me.
I just bought a really good LI-PO ready...

Last post

Orion, TrakPower, and SMC are all considered top notch stuff. They are all matched, hold balance quite well, of course a balance charger is still wise in my opinion. And they are known to actually make their claimed numbers, very good voltage under...

3 Replies

955 Views

Last post by Bongo Fury
Thu Nov 20, 2008 9:43 pm
Castle Mamba Max Question

Last post by civilguy « Sat Jan 15, 2011 12:01 am
Posted in Modern Electronics
Replies: 3
by top cat mike » Wed Jan 05, 2011 8:14 pm » in Modern Electronics

First post

I recently installed a Mamba Max 5700 into a Gold Pan RC10. I am experiencing what would be considered a glitch. On occasion when I press the throttle there is no response from the car. What am I doing wrong that would help correct this problem.

Last post

I think the OP is talking about a Mamba Max system which is sensorless, so they do cog occasionally. If there is actually no response at all when the throttle is depressed, I would run through the setup process for the esc. It almost sounds like the...

3 Replies

507 Views

Last post by civilguy
Sat Jan 15, 2011 12:01 am
Uh oh, problem with my Mamba Max Pro

Last post by RC104ever « Sat Jun 25, 2011 7:50 pm
Posted in Modern Electronics
Replies: 9
by RC104ever » Sat Jun 25, 2011 11:15 am » in Modern Electronics

First post

Hey everyone, so after trying out my car today with a lot of fresh and updated parts, the car just all of a sudden stopped dead and the LED's were all on solid, not flashing. What's that mean? Couldn't find anything on the Castle website.

Last post

Problem solved - I disconnected the ESC from the receiver and was able to reset everything. Weird.
Do you run an HG alloy diff gear? :P

Probably not since I don't know what that is! :lol:

9 Replies

1240 Views

Last post by RC104ever
Sat Jun 25, 2011 7:50 pm
Mamba Monster calibration issues - help!

Last post by Momo5 « Fri Nov 30, 2012 7:03 pm
Posted in Off-Topic / Chit-Chat
Replies: 4
by Momo5 » Thu Nov 29, 2012 1:03 pm » in Off-Topic / Chit-Chat

First post

Hey fellas. My neighbor got a used E-Revo with a mamba monster/2200 combo. It didnt come with a radio so I offered to let him use my Flysky FS-GT3B for a while until he can buy a new radio. The problem is, I cant get the radio to calibrate with the...

Last post

Still no luck. Maybe I'll try and call castle and see what they have to say.

4 Replies

880 Views

Last post by Momo5
Fri Nov 30, 2012 7:03 pm
Question about Mamba Monster ESC set-up?????

Last post by THE H.P FREAK « Wed Mar 30, 2011 3:46 am
Posted in Modern Electronics

by THE H.P FREAK » Wed Mar 30, 2011 3:46 am » in Modern Electronics

HI!... O.k I've been running the Mamba Monster ESC/MOTOR combo for years in a bunch of my 1/8TH scale cars/trucks. I've always ran two 7.4 volt lipo's together to get the 14.8 volts. Now I bought a single 18.5 volt lipo due to I did a electric...

0 Replies

551 Views

Last post by THE H.P FREAK
Wed Mar 30, 2011 3:46 am

Return to “Modern Electronics”

Who is online

Users browsing this forum: No registered users and 4 guests

mamba misery

mamba misery

Re: mamba misery

Create an account or sign in to join the discussion

Create an account

Sign in

Who is online

Login Register