I found some original wing tubes. I know that the B3 wing wire is too small, is the proper size still available (from AE, Tower, etc) in a kit with the wing, wire, etc.?
sneako43 wrote:I found some original wing tubes. I know that the B3 wing wire is too small, is the proper size still available (from AE, Tower, etc) in a kit with the wing, wire, etc.?
Thanks
You can use the smaller wire. Just put a small kink or bend in the wire and it will hold fine.
sneako43 wrote:I found some original wing tubes. I know that the B3 wing wire is too small, is the proper size still available (from AE, Tower, etc) in a kit with the wing, wire, etc.?
Thanks
I used a set of nose braces that I cut down. they are the same tube and tower has new ones in black that can stay that way or be stripped into bare metal.
Im working on attaching a wire wing to the pod of my 10L and I cannot seem to identify the name of the part that mounts the wire to the pod. RC-10's use those two aluminum posts pressed into the rear bulkhead. Im looking for similar mounts for the...
I don't remember who made it and haven't seen one in 20 years but I'm sure someone here does. It was carbon fiber or graphite and was a gentle curved shape. There were no side dams on it. Does anyone know of it?
Last post
Was it the Twinn-K aerofoil like on my LTO buggy? I got two of them from Johnny several years ago. They included pieces of clear plastic tubing that you had to glue into the cf piece, then you threaded screws into the tubes to attach the side...
So,I got my vintage Bud's wing mounted on my JRX2...It's a whopper of a wing-I need some feedback.
Is it too much wing for the car? Should I trim it down,maybe at the rear of the side panels?
Please let me know what ya think...Maybe not enough car?!
Last post
So,I got my vintage Bud's wing mounted on my JRX2...It's a whopper of a wing-I need some feedback.
Is it too much wing for the car? Should I trim it down,maybe at the rear of the side panels?
Please let me know what ya think...Maybe not enough car?!...
Silly question I know, but here goes. Obviously lexan is painted on the inside, but for a wing such as the jrx-2 v-wing, which side of the fins do you paint?
Do you paint the outside of the fin, continuous with the underside of the wing? (being lazy...
Last post
Those are the easy wings! A lot of the older wings by kyosho (and Tamiya?) had fully molded side dams: very annoying to get the first color to go all the way in the small cavity without getting runners. If that first colour doesn't go all the way in...
Does anyone still sell the original small rear wing? or does anyone repop them?
Tower has only the larger 6 inch rear wings and other stores the same.
Thanks
Qball
Last post
no longer available/produced, but they are still out there. as far as repros i know of none