TCS for 91 works. Orig/improvised

[slow_jun]

Hi Alex,

it is assumed that we do not have the TCS available to incorporate a customized slipper, i think the only way for this is to create a new customized lay shaft which i think Jake can manufacture ( its not that im implying jake ) .

but would this Layshaft for Hydra do the job for us?

[crusaderlyf]

where did you found this awesome item！I look after this for a long time

[slow_jun]

well you know.....i have lots of friends..... the lists is long , but distinguish.. i dont have it yet but soon to be. just need to confirm if this will fit the B4 slipper (which i think it will) assembly but which back plate will be used?

would you know how much this will cost?

[aip47-2008]

Hi Alex,

it is assumed that we do not have the TCS available to incorporate a customized slipper, i think the only way for this is to create a new customized lay shaft which i think Jake can manufacture ( its not that im implying jake ) .

but would this Layshaft for Hydra do the job for us?

I would love to have this shaft copied for all to use for dual disk slipper from Losi or the B4

[jwscab]

I made a very similar top shaft for jkracing's pro radiant. If there is interest I could probably make a handful. I'd have to mock it up and check it out. What do you use for the rear drive pulley with that shaft?

[aip47-2008]

A stock slipper TCS plate. This one is 2mm. Even the MR4Bx plate will work.

[jwscab]

If someone has one I can use for mockup, I can start looking at it.

On second thought, I think I might actually have one already in my stash of crap.......

does anyone know if there is a readily available 15 tooth pulley that would work as a replacement for the yokomo part? If one can be sourced, it might be easier to find and be used with B4 parts than the yokomo part.

[Mr. ED]

If someone has one I can use for mockup, I can start looking at it.

On second thought, I think I might actually have one already in my stash of crap.......

does anyone know if there is a readily available 15 tooth pulley that would work as a replacement for the yokomo part? If one can be sourced, it might be easier to find and be used with B4 parts than the yokomo part.

Maybe the academy wyvern pulley could be used? I have a bunch of them: both standard and one-way.

[Peakey]

A stock slipper TCS plate. This one is 2mm. Even the MR4Bx plate will work.Picture 100.jpgBX 670PA.jpg

Apparently the ID of the BX plate is 4.75mm where as the yoke one is 5mm I’ve not tried one yet but if I can get som emigrated be having a shaft made to utilise that plate

[aip47-2008]

A stock slipper TCS plate. This one is 2mm. Even the MR4Bx plate will work.Picture 100.jpgBX 670PA.jpg

Apparently the ID of the BX plate is 4.75mm where as the yoke one is 5mm I’ve not tried one yet but if I can get som emigrated be having a shaft made to utilise that plate

Just ream the part to 5mm. What I would do.