My rc10gt brushless conversion

Post by **Dirtcar75** » Wed Nov 28, 2012 1:28 am

My rc10 brushless project i designed and mare a mount out of flat aluminum it drives amasing ! Im goin to run carpet indoor oval and maybe offroad it all depends if i can get a setup that works ok both ways

Post by **Charlie don't surf** » Wed Nov 28, 2012 1:36 am

Customworks RC makes one for their older DD cars that is machined, in case your formed one fails

Post by **Dirtcar75** » Wed Nov 28, 2012 1:43 am

Charlie don't surf wrote:Customworks RC makes one for their older DD cars that is machined, in case your formed one fails

And it will work with the laydown gt trans? I have a cw rocket and it uses the old style stealth T/B3 actually and they mount diffrent.... One of the oval places sells a machined mount for like $20 but it dont have an esc mount built in and there aint much usable space to mount it.... Its made out of a peice of an old kirky race seat it shound be ok i have bashed with it for about 6 packs so far only problem i had was it flung the pin out for the old style slipper and chewed a gear when the pin hit the motor mount.... It drives really great actually! Im excited to try it in open oval!

RC10Talk - The Net's Largest Vintage R/C Community