I am trying to get my 4-10 legend kit installed and running. Was hoping to use the ten4 bulkheadhead and bearing set up vs cutting mine and sourcing the idler kit.
Any guidance or help on sourcing the ten4 hardware kit would be helpful. I have been trying to connect directly with Brian, but no luck so far. I purchased the bulkhead from Shapeways.
Ten4 Nose tubes and hardware kit pre-preorder
Moderator: mk-Zero
-
mk-Zero
- Business Member
- Posts: 1678
- Joined: Fri Jan 03, 2014 2:14 pm
- Location: Orange, CA
- Has thanked: 4 times
- Been thanked: 19 times
Re: Ten4 Nose tubes and hardware kit pre-preorder
I responded to your PM. Sorry for the delay, I've been traveling on a very hectic schedule and not keeping up with email and the interwebs.Mwp1111 wrote: ↑Sat Sep 28, 2019 9:16 am I am trying to get my 4-10 legend kit installed and running. Was hoping to use the ten4 bulkheadhead and bearing set up vs cutting mine and sourcing the idler kit.
Any guidance or help on sourcing the ten4 hardware kit would be helpful. I have been trying to connect directly with Brian, but no luck so far. I purchased the bulkhead from Shapeways.
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 14 Replies
- 1296 Views
-
Last post by justinspeed79
-
- 6 Replies
- 952 Views
-
Last post by Lonestar
-
- 13 Replies
- 1290 Views
-
Last post by marlo
-
- 7 Replies
- 1570 Views
-
Last post by RC10th
-
- 9 Replies
- 914 Views
-
Last post by SteveK
-
- 0 Replies
- 560 Views
-
Last post by KidAgain
-
- 7 Replies
- 897 Views
-
Last post by rctenracer
-
- 6 Replies
- 474 Views
-
Last post by JosephS
Who is online
Users browsing this forum: No registered users and 1 guest