It's been a little while since i've built a diff and replaced my trans gears in my old ride. Thats a much modded 10T sport for reference.
First, whats the best lube to use on the internal gears? And should i clean the grease out of my new bearings...
Wondering about just the CVD bones, I'm guessing the B4's are longer but does anyone know what the actual lengths are? I *think* I used B2 CVD bones on the rear of my car with the MIP RC10 CVD kit so I could use the Klein arms or maybe I used B4,...
Last post
Ok, so then what I must have done (can't remember now, lol) is use the B4 CVD bones with the RC10 stock axles.
If i have standard or RPM arms on my 10T and install RPM 70272 carriers and bearings along with b4 axles ( same as the WOIN buggy builds)......do i just need to swap the bones to T4 9569 parts to get the correct length CVD?
Last post
I was just about to press the button on some T2 CVD`s when I lucked out and found these 3/16 axels in my parts box....never had a T2 so I guess they must be from a B2 that I had???
I used the rest of the parts from the Gas Truck CVD`s
I got a set of shiny cvd bones in with a set of GT parts. They are too long to git the GT, but only by a little. I pictured them below next to a set of aluminum cvd that I know fit the GT. Are these perhaps T4 bones?
if not any ideas as to what they...
Last post
losi generaly has a bigger ball on the end and should not fit associated outdrives.
Hi.. what cvds would I put on an rc10 championship edition stealth tranny, and what all would I have to change to get them on? any help would be appreciated
Last post
follow-on question regarding the stock rear hubs. I have a buggy that has bushings instead of bearings for the hub. What size of bearing (flanged or unflanged) does the stock RC10 hub take?
well, my B2 requires the un-flanged 3/16x3/8. All of my bearings are flanged. So, for the rear carriers I used my flanged bearings on the outside, and (sigh) bushings on the inside. I can't do both as that causes not near enough clearance for the...
Last post
Hey thank you! That's more like it. Our lhs wants $6 a pair. Are Avid bearings any good? Or are they that cheap for a reason.
Volume sales; sell tens of thousands of something and you can charge less for them.
Hello, I looked for this info and had no luck.I am sure it is here somewhere or maybe I missed it.Sorry,I am sure this has been asked numerous amounts of time. I am looking to convert my 10t to 3/16 cvd's.What all is needed to do the conversion?Also...
Last post
I have a set of RC10T MIP CVD's NIP can i just get the 3/16 MIP T4 axles to use instead of the 1/4 10T ones?
Do you also need to replace hubs to do this conversion?
Google Adsense [Bot] and 1 guest