RC10Talk - The Net's Largest Vintage R/C Community

Hobbywing XR10 Stock Pro and 17.5 Xerun V10 G3 motor installed, along with a 72 spur and 27 pinion (needs a 28).

Saving up for a servo and a shorty lipo

They do look awesome on a display piece, definitely, if you feel the urge to run your car with the vintage tires, do so on low grass or maybe sand, where you know it’s not too abrasive to the tire and it’ll clean up easily.... I’ve used the Traxxas 2.15 spiked tires, which look vintage, and they per...

Gave it a bit of a nose job, it was feeling self conscious, so it got a bit of plastic surgery

Biz73 wrote: ↑Mon Jun 08, 2020 12:18 pm Looking good. What are the tires on the front?

Traxxas Rad2 2.15” tires

Tell me about it

I’ll be on the lookout for a Viper body, it’s a lot tighter against the chassis....this will do for now

Here it is, all painted up

I wish the yellow paint matched up better with the wheels, but that’s Ok

Awesome Nugget that thing looks Fantastic

Hacked and Mocked the body I got from eBay, not my favorite thing in the world, but it’ll make a good runner/basher body

So I got the B4 CVA axle in the mail today, and when compared with the Custom Works Medium Lenght CVD, it’s the same lenght, the problem is, with the b4 hub and Klein arms, it’s too short, and with GT hubs and Klein arms, it’s a tad too long, For it to work properly, I used a 2.5 mm of shimming or s...

Might order 1.18” B44 rear shocks to limit the down travel a bit, and it should be 👌 That can be solved with inner and outer shims on the shock shafts! And it should be indeed... because that's way too much travel on this suspension, the car will be crazy lazy and roll a lot before anything happens...

True...

It fits on the RC10, 10t, and T2, anything above that needs the arms to be shaved a bit for it to fit

Might order 1.18” B44 rear shocks to limit the down travel a bit, and it should be

Also, I ordered a Medium Length CVD Kit from Custom Works, and with the GT hubs, it wouldn’t get full up travel, sufficient, but not complete, because it would hit the inside if the outdrives, so I ordered B4 hubs, and used some creative spacing, and it also works fine, full up and down travel

Since I’m a restless RC person, I like to experiment, someone suggested the Custom Works front hex conversion, I ordered A set, mounted it, and it works awesome, the only thing is, you’d either have to use a long shank rod end, or use a shorter ball stud on the inner most hole on top of the caster b...