Search found 7 matches

by TA driver
Tue Jan 22, 2013 3:38 pm
Forum: Associated On-Road Forum
Topic: WTB RC 10DS CVD's where???
Replies: 2
Views: 510

WTB RC 10DS CVD's where???

I have a couple of RC10DS's and want to get another. I have mine equipped with Ti turnbucles, MIP ball bearing steering, Ti Hpins. These parts r hard to get. Anyone know or have a source for DS parts like.
by TA driver
Tue Jan 15, 2013 9:17 pm
Forum: 21st Century Modern
Topic: Need help B3 top shaft into a B4.2
Replies: 12
Views: 1736

Re: Need help B3 top shaft into a B4.2

I believe it's a Microsoft Excel program but I could be wrong.
by TA driver
Tue Jan 15, 2013 9:13 pm
Forum: 21st Century Modern
Topic: Need help B3 top shaft into a B4.2
Replies: 12
Views: 1736

Re: Need help B3 top shaft into a B4.2

Im refering to the RC speed calculator I believe theres different ones for brushed motors for brushless and problably more.
by TA driver
Tue Jan 15, 2013 9:07 pm
Forum: 21st Century Modern
Topic: Need help B3 top shaft into a B4.2
Replies: 12
Views: 1736

Re: Need help B3 top shaft into a B4.2

I thought the RC calculator needed the roll out of the driven wheels for the calculation. Voltage Motor Gearing Tranny ratio Roll out then theres drag and frictional losses but in this case there was very little or can be excluded as the B3 was rpming out and motor temp was slightly warm. Roll out i...
by TA driver
Tue Jan 15, 2013 8:56 pm
Forum: 21st Century Modern
Topic: Need help B3 top shaft into a B4.2
Replies: 12
Views: 1736

Re: Need help B3 top shaft into a B4.2

Forgot to include the drive wheel roll out. But the foam wheels/tires are shorter than the factory wheels and pin tires. Not at home at the moment to get the roll out. Was trying to get an idea how fast my buggy was I think the B3 is a 2.4 tranny. Don't have a B4 yet and don't know if the B3 foams w...
by TA driver
Tue Jan 15, 2013 8:25 pm
Forum: 21st Century Modern
Topic: Need help B3 top shaft into a B4.2
Replies: 12
Views: 1736

Re: Need help B3 top shaft into a B4.2

I had a B3 back in the day and installed an 8201 HPI 2 speed in it. It would RPM out w/ an 18 turn mod motor. It was very fast and run time on 6 cells was around 35min. Motor would barily be warm and the LRP speed control same barily warm in the summer. I lightened it with aluminum blue screws lower...
by TA driver
Tue Jan 15, 2013 5:49 pm
Forum: 21st Century Modern
Topic: Need help B3 top shaft into a B4.2
Replies: 12
Views: 1736

Need help B3 top shaft into a B4.2

Have been out of the hobby for about 18 years just now getting back into it.

Looking to swap the top tranny shaft in a B4.2 with a B3 top shaft. Can this be done?
If this can be done I will buy a B4.2
Thanks for any help.

Go to advanced search