RC10Talk - The Net's Largest Vintage R/C Community

Thanks that would be great!

I think this is good to go. Added some extra holes for the shorty from Vintage RC.

Thanks, yes I can shorten the front. I think length is good overall in reference to the holes.

The dog bones are TCP. I was using that for the fitting.
Different car.

Printed out the front and the rear of the car and attached some parts.
Looks good to me. Anyone see anything? Is the spacing between the bell crank and tie-rod on the tower look correct?
Next I will finish up the battery holes.

What is the standard Chassis thickness for these?

Found a Drag Link so now I just need holes from bend.
And from steering post hole to servo hole.

Thanks Much! Almost there. My length is the same now and front hole to bend is good. Just need a few more measurements. Center of bend to Steering rack hole and distance between steering rack holes. I want to double check that the TRX3/TCP and TRX1 are the same layout. Last thing to do is get some 3...

Ok I thought you measured to most rear hole. I measured again in CAD and am at 288 to rear arm mount holed from center of the bend.

Is that the shorter chassis? I adjusted the holes in the front to the center of the bend, that is an important measurement. I have a fairly good picture I used to get a rough Idea and also some measurements I took years ago. Front hole to Rear Hole I am at about 10mm difference than your chassis. Do...

Thanks, I am at about 341mm.
If possible can you measure from front Bumper hole to rear most hole? I think this is a more critical dimension.

I almost have the Chassis CAD done. I based it off the TCP chassis that I have. I will need to 3D print the front and rear of the chassis to test fit parts. Does anyone have the overall length of the TRX1 Chassis. I have a source for material and our machinist at work may have a local supplier that ...

Saw that Transmission on Ebay, nice snag. Cool to see a prototype like that, or at least that is what it looks like.

yes, I made the mistake of not making the chassis in CAD when I had one.

I do have some measurements, and can get others from mating components. Not too many holes in that chassis.

I think I have a company that can make these Chassis. Does anyone have CAD or a drawing of one? The person that got them made back in 2013 may not be active on the board anymore. I emailed but I have not gotten a response. It looks like I have enough info to make a TRX1 Chassis. So I changed this th...

Very cool. I am in the process of gathering parts to build one.
miss the one I sold.

Some parts arriving. More this weekend....
What did I do? Now tracking down TRX-1 parts.
I will rebuild the ones I regret selling.