RC10Talk - The Net's Largest Vintage R/C Community

I am looking to upgrade the ball cups and turnbuckles on my RC10 Dual Sport.

However I am not sure which brand to go with or what sizes I need as there seems to be a wide range

I am leaning towards all metal and I want to stick with black for both the ball caps and turnbuckles.

Any suggestions?

I am looking for an alternative tire for my HPI Vintage 8 spoke wheels. I have Vintage Racing tires mounted but I need something with a higher profile that will give a beefier muscle car look.

Any suggestions?

i'm gonna post some this weekend.

The B3 carrier actually is working out fairly well so far. It has decrease the rear track just enough for the wheels to tuck in the body. I am still on the look out for a drive shat that measures approximately 40mm in total length. I tried HPI Racing's drive shaft part number 86193 and found that th...

When I give it positive camber it articulates batter.

I won't be able to tell for sure until I trim the arm so that the outdrive has proper clearance.

I just order a Dremel 231 Routing Table so that I can make neat work of it.

Yes, I did shorten the camber link and I am using separate separate doggones and axels.

I don't want to give up just yet! Hopefully I can find some shorter doggones that will fit.

Not 100% sure how this works but when I articulate the arms w/o the ball joints connected everything moves just fine. It's only when I connect them that I have an issue. Is there something that I am missing?

I just got the B3/T3 rear hub carries in the mail yesterday! The good news is that my challenge of narrowing the rear track by 5-6mm seems to have been achieved. The bad news is that I have to trim the hub carrier to allow for clearance of the wheel and I have to trim the rear arms to allow for clea...

You guys will be the first to know how it works out!

SWEET!!!

Def post some picks w/ the body off!

End to end: 46.5mm
Center of pin to center of pin: 40mm

Thanks fo the link!

I hope the dogbones will still fit w/o binding. I am crossing my fingers.

Aside from trial-and-error, is ther a good way to find dogbones that will fit properly?

Please clarify. Is the B3 and T3 versions of the RC10?

Thanks a million! I just ordered 2 pairs on Amazon.

Oddly the Team Associated site did not recognize the part number.

Is this the right part for the B3 hubs?

http://www.teamassociated.com/parts/details/7358/

http://teamassociated.com/parts/details/6366/