RC10Talk - The Net's Largest Vintage R/C Community

I sent him a FB message just now since I am also interested in the progress. He was very helpful when I had questions about his B2 Vonats buggy.

Thanks for composing this list.

I believe #7335 should be 7338 since I have a nip set of them.

#8009 "World's" Spring & Ball Cups (2 ea.)
#8029 "World's" Soft Front Springs <-- yes they are yellow

Ronbo wrote: ↑Thu Oct 03, 2019 1:04 am What is exact part number for the Custom Works CVDs? Any work for the 10T?

7210 for buggy up to B3

The high end build would have all Made in USA parts.

Yet another spectacular build. Really nice to see what you've been able to do with it. I was content with the way it was, but these mods take it to another level. Save those vintage Losi ballcups and early thin rear arms/hubs that it came with.

PDF's
Images

Dynotech has titanium ones on eBay for $75 clams. If they aren't listed just send them a message.

Warrior and Big Fin wing kit

Yes, they will work.

Were there ever Monster Horsepower Pink Label motors with a silver can (Trinity not stamped or engraved at bottom of can) and a black plastic Epic endbell? Endbell is held onto the can with the two tabs on the can, not screwed to the can. All pink labels I've seen so far are black cans and say Trin...

That's a nice canvas to work with. I'd start by dying all of the nylon and towers black.

You won't use the round plastic spring cup to the left of the spring in your pic. You do need the smaller one (LOSA 3124) that goes on the end of the small spring (only use 1 of course) with the nut topping it off. Not sure if a plain washer would suffice since there is nothing to keep the spring ce...

Possible Composite Craft with lexan dust shields attached w/ servo tape.

Let's go Brandon!