RC10Talk - The Net's Largest Vintage R/C Community

Scored this on Ebay for $38 shipped for the Dominator...everything works including the brakes


Here it is after a restoration

I don't think its authentic... They are green at the ends but the sides are silver, smaller diameter wire, and they do have balance holes drilled.

To clean the comm superfast just chuck the pinion side into a cordless drill, while its spinning hold #0000 steel wool on the comm...it will look new in seconds

....just two of the finest vintage rc products from back in the day....that's right folks, Platinums and a Novak 4 (best and most nostalgic esc ever made)...these are facts not opinions :lol: Just tested the Novak 4 and it works perfectly, BEC, brakes....will get rewired but case in premium conditio...

Its has been driven so far for over an hour , mostly on road but with some short grass as well so it's been fully loaded not just bench tested , no real value to bench testing , my feeling is they are good to go but if the consensus is to go another hour of road testing then I guess I'll just have ...

RC10resto wrote: ↑Fri Apr 08, 2022 11:13 am Wow, just wow
If I didn't know you had a Wife and Daughter...

Lol, actually it's a quality tune, always brings me back to the rc days of the 80s

Cool to see....just got a set of his wheels in for the 4:10....amazing quality!

HiCaps, another T4 (works perfect), custom front tower for the 4:10, decals for Thumbs car...sweet little delivery

Its not finished but getting close, shocks not right yet so still trying to dial that in, trying a 3rd set tomorrow, hopefully: hint (premium Tamiya)...the body is finished along with the electrics...here's a sneak peak

20220413_153343.jpg 20220413_153054.jpg 20220413_160135.jpg 20220413_160110.jpg 20220413_160042.jpg 20220413_160018.jpg Just waiting on new springs for the front shocks to get rid of the adjusters, these springs are too short (front end will ride higher)...the shocks are Tamiya HiCaps

Race Prep I think

Le Mans 360 Gold

Restored the chassis

I have repaired many Le Mans motors with 3m knurled inserts from Ebay...works perfect....make sure u drill properly and I used a vice to press them in