RC10Talk - The Net's Largest Vintage R/C Community

I'm just glad I was into vintage r/c before it was cool. Vintage has always been cool, just not popular! I wouldn't mind a YZ10 also, since I don't have any 4wd buggies to race (except a Manta Ray). RC10Talk sponsorship for the Godfather to get a YZ10, I'll throw in $50 to get it started Don't go s...

I'm just glad I was into vintage r/c before it was cool. Vintage has always been cool, just not popular! I wouldn't mind a YZ10 also, since I don't have any 4wd buggies to race (except a Manta Ray). RC10Talk sponsorship for the Godfather to get a YZ10, I'll throw in $50 to get it started Don't go s...

My distant cousin (2nd cousin once removed) is the singer in this group. He and my nephew are pretty close. I just realized he's in a few of their videos.

I would like a XX of my own for comparison testing. Not to race though as I'm not interested in loading up on spares. Plus you'd have to accept how much better of a car it is than an RC10 and that would be a hard pill to swallow. Sorry, couldn't resist. :lol: It tends to be the AE cars on top in 2w...

You're looking for 2.2 wheels to fit the modern carpet tires. Those are small diameter like the stock jelly bean wheels. 7171 wheels + FW adapter https://www.amainhobbies.com/traxxas-2.2-dished-wheels-white-2-tra7171/p172189 https://factoryworks.com/shop/ols/products/1020 JC Racing wheels https://ww...

Uh oh, what I miss? :lol: :wink: I know the MIP CVD's is one, but it at least has the CVA's. I also didn't discuss trimming the wheels. I realized I missed the CVD's after I was after I had completed editing the video. I didn't want to dig the stuff back out and film it, then redo the video :lol: . ...

No template. I drilled the new hole, then cut off the larger portions that needed to go with a dremel and cut-off wheel. Then used a sanding drum on the dremel to do the rest.

Here's the build thread of my car. There's a pic of the bulkhead just sitting on the bench after the mods. Also notice my screw up on the antenna mount. I angle cut the wrong side by accident.

https://www.rc10talk.com/viewtopic.php?t=41196

My rear one is actually too tall. It doesn't let the body sit as low as it should. I'd have to dig the car back out, but they're the same diameter as a stock body mount. 8-32 screw. The rear one has the same pin height as a stock mount, but the pedestal holds the body up. May need to be 3/16" t...

Not sure on the wing tubes. I'd have to measure and compare them to others

Bulkhead ball stud will be the same as the rear hubs and castor blocks (.300 I believe)

You may have to chamfer the holes on the nose plate sligthly to allow the screw to seat properly.

The RC10 versions are the same weight as the mono wheels. I'd assume the modern ones are no different.

I was debating making a part 2 to my video to address a few things. The CVDs being one, and maybe a few detail RougeIV mentioned like removing the ano on the back end of the nose plate. But also in regards to the gear cover. No, the stock cover will definitely not fit a Hydradrive, nor will the one ...

Modernized replica of Masami's 1994 Winterchamps win. Raced at the 2024 Vintage Off-road Nationals.