RC10Talk - The Net's Largest Vintage R/C Community

In the hunt for good deals I tend to pick up used ESCs and receivers in need of a little rework. These 2 Novak ESCs needed the standard case cleanups, wiring unsnarling, receiver connector repair, and power switch replacement. For the switches I wasn't satisfied with the standard options that always...

Got a 2nd JRX2 finally and quickly assembled it into JRX-Pro configuration-ish. I printed stuff at my fastest settings and well quality and durability suffered a bit and I broke a rear arm on shake down. I'll try again soon. https://i.postimg.cc/Wh7myswX/IMG-20220915-202149041.jpg https://i.postimg....

"Ugly Truckling"

Also just noticed "Location Ill Noise"

Cool project ! I made an equivalent with a Jrx2

Looks like it's shaping up nicely. What's that motor in front of it? Some sort of Trinity stock?

More SG Coyote , this time the front pumpkin , all lines up with an original.

so a my order from Shapeways came in for the wheels. They came out great! https://i.postimg.cc/CBzQZ34Z/IMG-20220917-131532166.jpg https://i.postimg.cc/qtmFvJ2V/IMG-20220917-131536821.jpg https://i.postimg.cc/KKcVbkkD/IMG-20220919-093037478.jpg Also I picked up some premounts meant for the Mini B an...

I wanted to save these 2 new pivot braces if possible. I had this well used Trinity brace that was very ground down on the 2 lower corners. I wish I had taken a before picture. It looked trashed. I spent some time sanding, stripping, and polishing. It turned out pretty good and it should do the job ...

Friday I finally got my new project in. The previous owner must have really liked Miller. https://i.postimg.cc/DSQMfQDG/efafafafa.jpg https://i.postimg.cc/v132fYGH/efeaefefea.jpg https://i.postimg.cc/5XWrMKP1/ergervaewe.jpg https://i.postimg.cc/1fqd21rJ/rgrwgawffvas.jpg https://i.postimg.cc/kVnh263p...

It's been a while since I found a bargain on ePay.

Scored this Falcon for $130 Aud minus the acoms transmitter (found that at a local garage sale)

The one improvement I'm aware of with the re release Blackfoot is an important one, the outdrives and dogbones. The original had hex shaped dogbones that were prone to getting rounded off. The fix was to get a Thorp setup. The new version is the standard ball/pin dogbone setup that it always should ...

I was lucky to find this gem not long ago. More than I would have liked to pay, but very fair price I think. It was one of my childhood favorites. Only an original was going to please the void for me.

I've gotta find that 5108 to fill in my collection. Does anyone know what 5109 or 5111 are? (assuming they weren't skipped) The 5110 complete set has a ball bearing center gear and the deeper recess side gear as well, didn't know it was available separately though. 5100 Diff gear set 5101 left gear ...

If they are 1/8" hinge pins, Custom Works E clips work good and are cheap.

If the grooves of the pins are worn, maybe use a 3mm E clip. I've had to do that with several RC10's.

She's a runner now. The electronics layout isn't pretty, mostly becuase I have the battery adapter cable and lipo voltage monitor that i use to run on my older electronics. The Futaba ESC is pretty damn nice. need to do some swapping of tires and such before I run it on a track. I found that JC Raci...