Search found 5 matches


by aeiou
Sun Apr 07, 2013 9:45 am
Jump to forum
Jump to topic

Re: Alluminum & Carbon fiber Build

Here's a comparison using a couple of older AE bulkheads (Early/long wing tube version on far right): IMG_3499.jpg Here's the Andy's bulkhead connected to an REC gearbox with AE graphite brace and included spacers: IMG_3502.jpg I'm not sure what's up with your situation gomachv, but I know you purch...
by SiRacer420
Thu Jun 02, 2016 4:09 am
Jump to forum
Jump to topic

Re: Three new trucks

I had it on Imperial but it was giving stuff like 24/128

Metric is just easier to read. (I never thought I'd be an advocate for the metric system.)

There are a LOT of different parts on this one. Mostly hardware.
by RC10th
Fri Dec 09, 2016 9:45 am
Jump to forum
Jump to topic

Re: RC10T - "Red Truck" Out Of Retirement

I should try some two hole arms as the front is still on the softer side with #3 piston and 40wt oil.
by jwscab
Mon Jul 23, 2018 4:41 pm
Jump to forum
Jump to topic

Re: Aftermarket SC10 Shocks for 10T?

there are lots of rc10t shock lots on ebay usually. Unless you need NIP, those are usually a great deal. this seller is a very good guy:
by radioactivity
Sat Aug 22, 2020 9:30 pm
Jump to forum
Jump to topic

Re: 6 gear outdrive distorting bearings on one side?

Hi I've never run across that problem. Sounds as if something is getting tight when rotating. By "outdrive" do you mean the outdrive installed with both the idler and input shaft gears installed in the trans? If so, it is probably the idler gear. I would think so because it is plastic and ...