RC10Talk - The Net's Largest Vintage R/C Community

Prepped my B6.4 for racing this weekend. had to put the electronics I borrowed for Roostpalooza back where they came from. Also, spoked wheels make this look so much cooler.

What are you planning on doing with it? XXt CR Graphite plus is a very capable vintage race platform. Transmission cases are weak spots, Jeff at Factoryworks.com makes a very cheap.trans brace tab that helps safeguard the cases (unless the T plate breaks too....and they can.... then both are trashe...

Nice 7001 kit right there. The front tires on the rear is a nice touch.

I painted a Jconcepts B74 body

Wow look at all that ip theft
(Ok trademark, whatever )

Track day report- Buggy wasn't bad, had some issues with the 25* castor blocks making the car tight in the center of the corners and slow to release the rear end so I could square up for the 3 sets of doubles. I would normally increase the rear tie rod length to get more rotation, but I'm limited b...

I would normally increase the rear tie rod length to get more rotation, but I'm limited by the 2 hole CR hub carriers. If you get the rear hubs from a XX CR Kinwald you get a third outer hole for the tie rod. 20250112_142310.jpg Unfortunately they used the same part number as the CR hubs (A-2126), ...

Robbed the parts bins and found enough parts to throw together a basher to test out the TPS style transmission. The trans held up well! Blew through a set of foams in a couple packs

I think the "no copies" sticker is a hint of something to come in October. Could be wrong...

I just resurrected my Team Associated RC-10 2T Championship buggy from a long slumber and found this forum. Purchased new in 1991 and using an MSC and Futaba controller and electronics. Old NiCD battery holds a charge for about 3 or 4 minutes. So off to get a 3800Mah NiHM Tenergy and charger from Am...

Bolink Invader O/R, with original Bolink Dirt Tracker Corvette body. Greenwood Corvettes "Spirit Of xxxx" tribute scheme.

Build thread: https://www.rc10talk.com/viewtopic.php?t=50581

Cant see it in pic, but its got a 240s in it

New Parma Pro Panther.

JRX A-2025's Hubs maybe? More holes than any one person could ever know what to do with. Never mind, I think that would actually make tie-rod shorter, not what you are after.