RC10Talk - The Net's Largest Vintage R/C Community

Got an SC10, courtesy of the forum. Thanks everyone.

I have these on several brands of transmitters.

https://www.amainhobbies.com/jconcepts-dirttech-steering-wheel-foam-grip-2-jco3241/p443627?gad_source=1&gclid=Cj0KCQiAoeGuBhCBARIsAGfKY7xe_DVFqcX3BFK-b32-LWhcEQLJ__DguSpO3XusSWRrxLaDbZqkRyoaAlOKEALw_wcB

mAdMan wrote: ↑Sun Feb 25, 2024 11:06 am The Porsche 914 engine is a VW motor.

It even kinda sounds like a Beetle.

mAdMan wrote: ↑Sat Feb 24, 2024 9:46 pm

Lighter fluid is good for removing tape residue without damaging paint.

GoMachV wrote: ↑Mon Feb 26, 2024 1:41 pm A body I was gonna cut up and put on my Amain Bullet but I can't bring myself to chop it. Now I need to figure out what to put it on

It would look great on my Frog. Just saying.

Then soldered it all together and tested it again. Realized that it cuts power too the motor when quickly applying the brakes from full throttle. I cant say its suprising, considering the esc was $3, but I've used them before and never had issues. Any idea what could be causing this? Took a few min...

adam lancia wrote: ↑Thu Feb 29, 2024 5:58 am So the one piece axles would work with the Traxxas parts? Do you happen to know which specific part numbers I should be looking for?

Not off hand (I'm at work), but they are the regular 2WD truck parts

This is a AE axle in a Traxxas carrier.

Why limit yourself?

I use straight and curved scissors, X-Acto knives, sanding blocks, and a Dremel with various bits.

Here is mine. TBG body and MCI decals.
Mine isn't an exact original, more original themed car.

Do you know if the Traxxas axle carriers fit the B4 c-hubs? I have adapted the smaller (5X8) bearing type. They are only used on the brushed Bandit buggy (VXL's use the larger one) now. Rustlers and Stampedes also used them in the past. The two sizes are interchangeable on Traxxas carriers but I ha...

1911Colt wrote: ↑Thu Mar 07, 2024 3:42 pm Some bionic eyes were prettier than others....

The new one is very "Bionic".

Best I remember, the RC Screwz kit for the RC10 doesn't fit correctly either.

I buy a lot of my stuff from Team KnK.

Got the forum SC10 all electrified. Novak XXL receiver, Reedy 0712 servo, Radiolink esc, and a Spektrum 14T 550 motor. Screenshot_20240315_190531_Gallery.jpg Screenshot_20240315_190608_Gallery.jpg I still need to get a 8.4 flat pack (hump "fits" but it's kinda janky) dedicated for it.

It has truck conversion wheels and Tamiya Blitzer rear tires all around.

Probably an AB chassis.