RC10Talk - The Net's Largest Vintage R/C Community

Progress.

The blue paint on the rear springs is rough. I think this is pretty common with these kits though.

These have been the most difficult e-clips I have ever had to install.

Getting closer. I had this light blue material I used to wrap the receiver case. The color isn't perfect, but I wanted to try it. I will be replacing it with something closer soon. The XL-3 controller looks right at home on this car. I am trying to set my electronics as close to the box art/manual p...

Team Associated Fits Stealth transmission gaskets made with high density foam. Replace that broken down fuzz ball with a new vibrant gasket 💪🏻 Pm or email for inquiries to: Nostalgicrc@gmail.com https://hosting.photobucket.com/images/ww227/derbed70/IMG_9317.jpeg?width=1920&height=1080&fit=bo...

A really nice time capsule came my way. All it needs is a good cleaning and a body. The original owner seems to have taken really good care of it. I'm not sure if I'll go painted or clear with the body.
.

Enjoy! Dont forget to watch in 1080p HD...looks better,

I’m trying to run a dual ESC setup on a car. Both ESC are connected to a Y connector. One of the ESC I pulled the red wire pin and have it taped back. The car powers on and has normal operating steering and both ESC lights are synced well when I give the car throttle. But anything over 5% throttle i...

I did a temp placement of everything and did a shake down to see how it’s working IMG_2452.jpeg It’s geared conservatively, which was good give it 90+ in the shade at 11 in the morning. It runs good, just slow. The 27mhz am radio does not like having the antenna rolled up and tucked away. I may need...

I found some airplane wrap at my LHS in a color that is a great match to the wrapped receiver in the box art.

Hi!
A small picture (awful quality, as usual... ) of my built Losi cars.

Have a nice week-end!

Essejay

Here's my LX-T that I raced on carpet ovals as a kid. It's close to how it was back then, except for the .36" shocks and yellow motor plate. I ran A&L Roadkill & BTS Liberator, Dahm's Ruff- E-Nuff SE and Andy's Lo Profile bodies. I had Trinity Pushed 1400's but the Point Blank labels fi...

I considered one large brushless setup but chose doubles to save on fabricating a whole new motor mount setup as the can size would’ve required the motor to be reverse mounted like yours. Besides an angle grinder, drill, and some files I really don’t have many fabrication tools to be making custom m...

I did some light wet sanding on the wheels and finished up the wheels and body with some novus polish. It turned out nice.

Not today, but the two previous ones, there was a vintage event with onroad focus with a very nice big track adapted up to big scale rc cars (if you want to have a look to the track, here is the site of the club : http://www.camm71.fr/)... Went there with both my son and my daughter on Saturday. I d...

Can anyone tell me the width of the front bulkhead where the inner hinge pin passes through? I trying to figure out if standard off road rc10 front arms would mount to this bulkhead. Thanks

The Frankentruck lost its body to one of the EGTs. But it got an upgrade. The replacement was from a shelfer GT, but didn't quite work with the T3 rear shock tower. After a little trimming and the addition of a pair of carbon fiber RC10B4 hub towers for the shock attachment points, the body now fits...