RC10Talk - The Net's Largest Vintage R/C Community

You will need a transmitter (TX) crystal and multiple receiver (RX) crystals of the same frequency. I primarily use 75mhz channel 88. The picture is a bag of (5) ch 90 RX crystals. . PXL_20220626_213236541.jpg . Your 2PL is new enough to use both the earlier wide band receivers and the later narrow ...

I really like the paper original manual. Have to have one to read.

Came across this gem while watching YouTube.

The crashes are fun to watch in slow motion. The track Marshall steps on Ralph Burch Jr. car at 23:50! Ouch!

They are having a memorial race for Chuck Kimbrough at the Encino Velidrome on Sept 2-3. I’m gonna try to make it. I’ve always wanted to watch some speed runs in person after seeing videos like this one as a kid.

Enough BUZ11 FETs to refurb an ESC .

.

A couple of nice Modifieds, a Reedy pink dot and an unknown model Twister. Also a couple of stock motors.
. .
The one with only 2 screw holes has me interested. Seems similar to an earlier Yokomo can and endbell, but with no markings.
.

TravelinTravis wrote: ↑Fri Jul 08, 2022 3:28 pm Technically....delivered today...but will take a few months until I get back state side to pick her up! Very new Revtech to add to the collection! Stoked!Revtech15DJuly2022.jpg

Enjoy that motor since I was the seller.

Got this ultra sonic cleaner today, can't wait to use it.

Sorry for the downtime! The site wasn't responding when I went to sleep this morning but was far too tired to look into it. It appeared to be a minor server issue that I hoped would work itself out as they sometimes do. I woke up, and it was still down. :? I contacted support, and within 10 minutes ...

Been tinkering with this project for a few years and finally found a few parts that were crucial to the build to get me going , I tried to incorporate thee H10sc bottom chassis stiffener plates to form a top deck brace and wasn’t satisfied with how it turned out so I decided to make my own 1 piece s...

Got some fun today. Some of which I'm quite familiar with (Green Machine 2s, Midnights, Fantoms) the others not as much. Some of these have near 0 wear, like they were broken in and then just put away. 🤷 Never seen or heard of the Race Prep Chi Town Hustler, Losi Super Insane, or Pretty Puny Sissy L...

A Peugeot 405 body from the UK for an upcoming rally car build.

I don't really collect Hot Wheels, but I have a soft spot for KITT. Such a cool TV car. It seemed kind of like an oversized RC car. Maybe I'll need to see if I can make an RC replica someday with an oscillating red led light strip. It would be several cars back on the project list though. . PXL_2022...

You could give me one of the top pro drivers modern cars and I could guaranteed crash it into the wall harder than they could. I’m not sure that counts for anything but it’s a slow day.