RC10Talk - The Net's Largest Vintage R/C Community

RogueIV wrote: ↑Fri Feb 14, 2025 10:12 pm

ZED32 wrote: ↑Fri Feb 14, 2025 9:52 pm I could ger down with POS of the month. Worst car wins

One additional rule: POS of the month entries need to also run despite it's horribleness

I came across a great candidate, but it might be a ringer

That's a sweet Foot!

I put a 17.5 brushless setup in my TC3 a while back and it was glitching with my AM radio. I tried a Novak Polaris receiver and it was still glitchy. Tried a Futaba R162 Rx tonight. After adjusting the throttle range a bit, all was good.

Getting my Trackmaster Beltbox 🤔 ready for a build. I really wanted to put a slipper or hydradrive on it but the top shaft is really short. If I knew where I could get a top shaft belt sprocket, I would build a new top shaft. But for now it will just have a slipper eliminator. It does run really smo...

I like both the dedication to NiCd and to Dean's 4 pin connectors.

Took my B4 basher out for some street running. The Traxxarse XL5 ESC sometimes wouldn't allow reverse. I remember that's been a problem before with this ESC. I think I need to replace it with one of the $5 Spektrum units I got (thanks for the tip juicedcoupe).

AE bought out all the Ten4.1 kits....

Oh yeah, I still need to put a new connector on that little battery. Then it's wheelie time!

I might as well go buy my wife something nice now. We're going to have a fight after this is put out there for pre-sale.

Does it come with an innovative new screwdriver?

coxbros1 wrote: ↑Thu Feb 20, 2025 4:32 pm

Frankentruck wrote: ↑Thu Feb 20, 2025 2:57 pm I might as well go buy my wife something nice now. We're going to have a fight after this is put out there for pre-sale.

You currently have the scratch?...funds real low here

I have the itch to get it....

Nice turnbuckles and ball cups too!

Getting closer to wheelie time! Busted out my OG waffle street tires and got the connector swapped. That is some really light gage wire on the battery lead.
.

Needed a rear skid plate too. I learned that lesson with Fs#1. This is what I use for aluminum brazing.

Very nicely done!