RC10Talk - The Net's Largest Vintage R/C Community

coxbros1 wrote: ↑Thu Aug 29, 2024 5:00 pm but the bearings dropped right in perfectly!

After the feedback I adjusted the holes to the sizes I typically use. I don't like to modify customer files when supplied but once I sell to others I definitely try to add my $.02 haha

Got the RPM ballcups on. I had to cut down the camber link ballcups a little bit and the inner front camber link location requires you to trim and file the cup side a bit to clear the nose tubes without rubbing. IMG_20240829_200351623_HDR.jpg IMG_20240829_200404840_HDR.jpg Note that I forgot about t...

Finally finished my 40th Rere. Took long enough but was well worth it.

Can't ever pass up a good deal on a Le Mans.

Large Corally pit/work mat, car stand, some nylon+ locking nuts, MIP ball end hex (2.5mm) for motor screws + 3.25mm turnbuckle wrench, diff balls....and more tires/wheels.

Before there were battery bars we used braid.... which is probably still superior to a bar to be honest.


All soldered up

All ready for some Vintage Nationals action this weekend!

here is my vintage custom painted ford f350 dually with custom made rear spoiler, bug deflector and sun visor. chassis isn't as nice as the body but o well

Mines a small entry, and I mean really small. IMG_20240910_082337375_HDR.jpg IMG_20240910_082510939_HDR.jpg This is my NRC K24, a 1/24 scale Ultima Pro Replica with a lexan wing by Jason Cooper, paintwork by Dominator Airbrushing and custom mini 5 spokes by me. Really fun to drive, if not a bit over...

Something for the DS so I can run standard 1/10 pan car wheels and more RPM ballcups.

I'm sure we all remember the giant glass case of R/C cars at Toys R Us, and not to mention the aisle with all the NES flip cards where we would stand for as long as our mom would let us and try to determine which game to buy from reading the maker's outlandish descriptions and a few microscopic scre...

I bring a classic my brother and I completed. It is a 1996 Yokomo YR-4M. It is resurrected to absolutely mint kit form, including the odd tire combo that came with it new. Its got a cool jack shaft setup to operate the 4wd. Also, a super smooth high revving Tamiya 13T Dyna-Run mod brushed powerplant...

Gonna try again.

Tamiya Super Hornet.

While my NRC24's electronics were taken for the K24 I still haven't stopped doing stuff to it. Recently it got a fresh body painted up and I made some mini Turbo Scorpion wheels for it to match it's larger sibling. IMG_20240828_172253685_HDR.jpg I did notice that the rear track width of this car was...

Is a spacer needed under the front gearbox too? The spacer under the tensioner looks like it puts the lower belt run very close to the upper run. There is a decent gap there now, and with a longer belt (if I go that route), it will probably end up even closer because I will probably end up raising ...