RC10Talk - The Net's Largest Vintage R/C Community

I'm currently attempting to better organize the 'Other Makes/Models' forum by creating sub-forums within it for some of the manufactures. Hopefully this helps people to better find and contribute information. It should also help with search engine optimization. For some reason though, the process of...

If one of them has a broken servo , well it's done for really you could send it my way LOL
Pretty jealous , have fun

Really chuffed with how these came out , gears A,B and C for the Tamiya Holiday Buggy / Sand Rover , printed in PA12 CF fill Nylon . The genuine ones I have are old and a little worn so these will get an old gal rollin again .

They are printed with a 0.4 nozzle but using a little used setting in Cura , under Experimental settings you will find " slicing tolerance" , set this to "exclusive " . The nozzle itself is an E3d hardened nozzle . The slicing tolerance setting has three settings that adapt to th...

That's a very good proof of concept , considering you never intended it to be used in this way and it was early work it's far from anything to be ashamed of , next one will be spot on I'm sure :!: Most of the faults could probably be addressed by just reworking the buck , it would need sanding and f...

Remodelled the Holiday Buggy gears to fit 8x4x3 bearings , stock they just run naked on the 4mm shaft without even bushings , both gears now need a spacer as well now , I'll get a set pro printed next month to check the model then add them to my shop .

Full Holiday Buggy gearbox and gears , tried a render , needs better lighting . chassis v25.pngchassis v25 1.pngchassis v25 2.png Are you going to do a modernized version of the Holiday buggy chassis? :-) No Tamiya already did a re-chassis although I may do some mods to have oil shocks , this mostl...

Full Holiday Buggy gearbox and gears , tried a render , needs better lighting . chassis v25.pngchassis v25 1.pngchassis v25 2.png Are you going to do a modernized version of the Holiday buggy chassis? :-) No Tamiya already did a re-chassis although I may do some mods to have oil shocks , this mostl...

It took a week, but I think I'm pretty much done organizing the 'Other Makes/Models' forum. It was way worse than I ever expected it to by. There were also a lot of topics and whatnot that had to be removed. It seemed to be the catch-all place for just about everything. A new forum ended up emerging...

Done

That chassis looks like a beast to measure giving me Samurai flash backs

Holiday Buggy gearbox cover.

Finished the motor cover for the Holiday Buggy .

Test print of front end , its low resolution 0.28 layer height and I'm using up some ancient PETG but it all lines up , I. Printing the rear now but again using up old filament so it's funky translucent blue and won't be finished till morning .