RC10Talk - The Net's Largest Vintage R/C Community

There is an amount of adjustment in the locking of the centre differential, similar to a slipper clutch. The different output gear sizes in the main gear means if the nut is loose you get 2/3 of the torque to the rear wheels under power, with 1/3 to the front wheels. This will give you more steering...

Not sure if this helps. Very hard to photograph and get that line. Mine is the World Engines version (Academy)

Boki is close to me, a couple hours drive, and can do it non destructively however it's not a body he would usually take on with other more popular bodies ahead of it in line. If I could prove it would be a value for him, I'd be happy to try. I'm not sure why tbg claims the body is destroyed, I susp...

I recently bought some Polypropylene (PP) filament , the type of plastic used for Tuperware food storage containers . Reason being I was pretty sure it's what was used for PB Mini Mustang suspension components , I'm even more sure now . I'd seen a few YouTube tutorials on printing with it and althou...

I'm not sure why tbg claims the body is destroyed, I suspect he has a container full of the bodies that have been backpoured that are perfectly fine still :lol: The technology of the time when Bluegroove started meant that to get the best finish and sizing you backpoured resin straight into the bod...

20240104_184451.jpg There is a quick down and dirty solution though , most regular sticky tape is PP so you just tape up the bed and print on the tape , now I tried this but I used a smooth PEI bed plate that may have been the problem as the filament stuck very well to the tape but the tape peeled ...

Back when I was as school I did try making a mould and there is more to it even if you use plaster , we tried to do a Ford RS200 body and what we didn't expect was that the weight of the plaster bowed out the sides of the body and distorted it so you need to put a support frame around the outside as...

TBG had that problem with a TOJ body I sent them. When I got the repop from them, it looked like a balloon. Of course they couldnt do anything because the original was destroyed, so I sent them my 2nd and last new TOJ and they were able to successfully backpour it.

I'm so impressed with this PP filament , I've been doing some destructive testing on a couple of parts , firstly the first warped print I've been repeatedly bending it double then the other way , I've managed to mangle it but I can't break it :shock: then i though what about the suspension pin holes...

silvertriple wrote: ↑Fri Jan 05, 2024 5:04 pm I received very special parts today (including a collector NIP )

EAT IT eat it eat it

silvertriple wrote: ↑Fri Jan 05, 2024 5:04 pm I received very special parts today (including a collector NIP )

Interesting...
.

Just printed this Mini Mustang bumper mount in PP , entirely printed on support material , I thought it would be a thorough test of how hard it would be to remove the support material , I was pleasantly surprised , while it's not the easiest it was not as bad as I expected and the print surface afte...

The prototype car have a différent body for the wc 87 than the production car

6 screws drill in the châssis with nuts

I needed a tire truer for the 1/24, so I built one

What a mess
Video:
https://photos.app.goo.gl/uPZVVaT36g62et3c6