RC10Talk - The Net's Largest Vintage R/C Community

I got some goodies for the Big Bear project.

finally got some time to do some measuring and modeling, I am actually surprised how close the chassis are together, I was only measuring the new chassis shown in red, I copied the model for my no cutout jrxt chassis and layed it over the rough model of the new chassis and width and length is almost...

RogueIV wrote: ↑Wed Jun 14, 2023 4:49 pm Going to be honest, I didn't either haha. I think there's 1 more on ebay still.

Got my Gemini SLX NIB for less than the price of that lot... And @GoMachV maybe right when he says there is still some available at Mantua Models...

Working on a rough draft of some sideskirts, is a bit difficult with my pattern in this condition lol I think they will be thicker than stock when I have them ready, printing them at .5mm and then scaling it down would be a pain. this is just a rough modeling, trying to get the angles worked out fro...

Getting it mocked up...tough build...1000 measurements ...maybe more...no joke

How's this? First print in over 6 months.. wiped the bed down plugged the card in, pressed print. https://cults3d.com/en/3d-model/game/losi-mini-jrxt-chassis-skirts it is a quick toss together, I would recommend printing on fine settings I could probably beef them up somewhat and add some resistance...

Going for a world record attempt

I'm S L O W L Y making progress towards my Mini XX Worlds Prototype based on CLM's Pro SE/LXT chassis work and Mini B Wheels.

Too much going on in my life to really focus on it, though.

Thumbs will post video. Made a safe test run...had some issues... GNSS is hard to use, keeps losing Satellite signal...so i don't have those numbers yet...still learning that thing...anyway.. Rocket mount came loose, steering setup was off, hard to drive straight at beginning of run, brakes failed.....

Apologies for the delay. I been drinkin'...

This morning.

MIP pack pals. Battery pack cushions.

https://www.rc10talk.com/viewtopic.php?p=521664#p521664