RC10Talk - The Net's Largest Vintage R/C Community

My MT

I'm a bit obsessed with Sandkil's RC10

I think everyone loves this king cab. How could you not!

Rckicks 870c re-re

The king cab makes me happy all day!

RC10 B4 arms and towers. New charger because my Hitec X2 AC Plus screen ended up broke for some unknown reason.

RogueIV wrote: ↑Sat Feb 24, 2024 11:45 pm Well I didn't get it in the post but my LHS did, and I got to pick it up.
IMG_20240224_182556644.jpg
Also, does Yokomo not have spell check?

Doesn't every company have an engineeping division???

3 year update! :lol: It's this car's turn to race at the Vonats. I got one of the new Jconcepts scooped Mirage SS bodies painted by Darkside Designs late lsdt year. Finished getting it trimmed and mounted yesterday and started getting the stickers on. Missing a few yet. I have all of the electronics...

RogueIV wrote: ↑Sun Feb 25, 2024 6:05 pm

mikea96 wrote: ↑Sun Feb 25, 2024 5:22 pm

RogueIV wrote: ↑Sat Feb 24, 2024 11:45 pm Well I didn't get it in the post but my LHS did, and I got to pick it up.
IMG_20240224_182556644.jpg
Also, does Yokomo not have spell check?

Doesn't every company have an engineeping division???

I'm now changing my job title to 'Engineep'

That may become POPURAR

A body I was gonna cut up and put on my Amain Bullet but I can't bring myself to chop it. Now I need to figure out what to put it on

Not really my go-to method, but just something that I have tried and found it works okay - at least, for what I was doing. This is what I did for a couple of Minis a little while ago: HL01.jpg The headlight was left clear. I lightly scored some lines in some clear tape, to match the pattern of old-s...

Losi goodness

RogueIV wrote: ↑Mon Feb 26, 2024 11:35 pm .....Now I have a hard power cutoff switch.

IMG_20240226_233208385.jpg

Harder for someone to steal your car.

And it's basically done now! I redesigned and re-printed the transmission case and it's much better now. I reinforced the area that broke and I figured out a design trick to really help with fitting bearings into 3d printed parts - add a small notched cutout on any bearing recess and use the slicer ...