RC10Talk - The Net's Largest Vintage R/C Community

And that body you want to replicate will have the same layout as the blue body, just need to change the colors to match your likes.

They made the arms in white and they *were uncommon in the glass filled material during the production of the worlds car. They were on some CE cars.

Yeah it's a Cadillac car. And probably either had parts replaced or running changes made. It's also possible that some one fitted newer parts to a car missing pieces to get it whole again.

I've kept all my rc stuff in the basement for years. my parents basement was damp and dark. My basement is cool and dark. I have kept stuff out in the open, like on a rack, and in cardboard boxes and plastic bags. I don't seem to see any problems over the years, except some steel hardware rusted a b...

You can use a shim and a washer to approximate this spacer. Dunno offhand how thick it is but it's more than 1/16" and probably less than 3/32". You are really just looking to fill that gap so it all stacks and acts as a solid spacer. Factory works sells some stepped washers that are very ...

Not at all. The 2.4g signal really only requires you to have the antenna mounted away from other metal objects. You could use a shorty antenna tube, or on some cars I use a scrap piece of lexan and tape the antenna to it and tape to the servo or other flat spot and bend the lexan so it folds up, and...

Yeah I also think it was a running change.

check the 25yr thread for lots of details of difference between b2 and b3. A BUTTLOAD of info so be prepared https://www.rc10talk.com/viewtopic.php?f=35&t=13059 shorter answer: front and rear arms, c hubs, spindles, rear hubs, slipper, front and rear shock towers,trans plate, top plate, rear arm...

yes, your phone is listening at all times for keywords. targeted advertising.

Correct, you start to lose the temper of the alloy above 450F. Also why I don't recommend people weld holes shut. powder coat can also get close to weakening the chassis.

I run usually shorty servos when I can. It's hard to justify servos over 50 bucks for me, but I do have some. I have mixed results with the trackstar ts-d99x. it's fast and cheap. but my failure rate is like 40%. when they work, they work well. when they don't they severely glitch your system. I bel...

I have some updates! I had a bit of a change in part choices because, well, I just wanted to. Most of the suspension parts were already RPM, and I went looking for RPM rear arms. you may have seen my trade thread, I ended up finding arms, but the 91 worlds style, Along with them came the 'non-telesc...

Maybe these guys?
https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fp%2F1700128771

Not sure on diameter. Could maybe turn them or sand them down?

No problem. Hope they fit.

They looked available from several sources. Check around.

That is the main shaft for 870c/yz10. It has the stock front slipper setup but it has an aftermarket spur. Not sure if that has an adapter or if the pulley is attached to it. Robinson racing. I think the Robinson spurs switch out on that pulley that is unique to Robinson.