RC10Talk - The Net's Largest Vintage R/C Community

Thank you for posting your build. Very good both technically and aesthetically! Just got a GX delivery in my own mailbox, and this thread is an inspiration and setting a standard for my own build :D However, I want to make mine a race car, so will opt for a slightly different route regarding setup, ...

Got the chassis modified and restored

Scored these yesterday locally for the build...I will restore the motor too

Here's a Power Pacing Products OM-10 conversion for the RC10L that I recently finished. There isn't much info out there on this one, and only one magazine article on the company's later MID conversion. This conversion uses a narrow lower rear pod and t-bar with a proprietary bolt pattern. It also in...

It's a tie between the Novak 410-HPc and Tekin 410K. The M.troniks Monster FET isn't far behind.

Had to move servo over to clear the chain

Looks like the tops of the socket heads are pretty even with the top of the upper chassis. A little more noticeable per how close the rear ones look to the bottom of the esc shelf.

Not sure if I will run these tires or go Marwan 0T-66....still undecided on wheels

This is a special ESC recently obtained for my 1997 Yokomo MX-4 World Champ buggy. The Tekin M Star Gold is my favorite for 2023. The gold heat sinks should look sharp installed.
I believe both the gold and red label Tekins were the winning ESC's at the 97 worlds.

Some bodywork added to the evil twin. A little experimentation with Cricut patterns too.
.

Looking pretty good!

Good job! Can't wait for the big reveal.

Have you opened the bag to see if it's printed on the instructions?

I want to say 1994.